Installing TruRyde Replacement Tang Type Spindle Washer

Updated 05/29/2018 | Published 05/25/2018

Question:

this question is regarding your replacement spindle washer, tang type item # 5-101. does this 1/32inch tang type washer sit directly against the outer bearing, or is there another washer that sits against the bearing, and then this tang type washer sits against the other 1st washer? ... thnx

asked by: S

Helpful Expert Reply:

The Replacement Spindle Washer # 5-101 referenced in your question is designed for 1 inch, D type spindles. The washer will install right between the castle nut and outer bearing, and the tang on the washer is bent up to prevent the nut from turning. There is not an additional washer between this and the outer bearing on the hub.

I have attached an installation video that you can also check out.

expert reply by: Chris R