Recommended Brake Hub and Drum To Replace AL-KO 363216
Updated 05/21/2018 | Published 05/19/2018 >
Products Featured in This Question
Question:
I recently ordered a set of magnets for my axle set to replace AL-KO part number 623752. When I went to replace it I noticed that the drum itself is unevenly worn with ridges and grooves on the mating surface for the magnet. What replacement hub/drum would be required to replace AL-KO part # 363216. Bearings are L44649 on both inner and outer. Bolt pattern 5x4.5. If my brake shoes are evenly wearing and still have approximately 1/4inch of brake material remaining, should I replace them at the same time, or would I be ok to continue using them until they have worn down to 1/16inch to replace as recommended by the manufacturer?
asked by: Tyron
Expert Reply:
AL-KO was bought out by Dexter Axle years ago, so I recommend the Dexter Trailer Hub and Drum Assembly # 8-257-5UC3 if you have a standard spindle or # 8-257-5UC3-EZ if you have a spindle with the built in grease zerk fitting on the end.
As long as your brake magnets and shoes have even wear and are functioning properly, there is no requirement to replace them prior to the manufacturer's recommendation. If either of them have uneven wear, then I recommend replacing them at the same time with the Dexter Electric Trailer Brake Kit - 7" - Left and Right Hand Assemblies # 23-47-48 or the Electric Trailer Brake Kit # AKEBRK-2.
Product Page this Question was Asked From
Dexter Trailer Hub and Drum Assembly for 2,000-lb Axles - 7" - 5 on 4-1/2
- Trailer Hubs and Drums
- Hub with Drum
- Standard
- L44649 / L44649
- Standard Grade
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 12 Inch Wheel
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: etrailer Electric Trailer Brakes - 7" - Left/Right Hand Assemblies - 2,000 lbs
- Q&A: Solution for Trailer Axle without Grease Fittings for Easy Install of Grease
- Q&A: Availability of Replacement Hub for AL-KO 8440
- Q&A: Which Wheel Center Caps for Forest River Flagstaff Pop-Up Camper
- Q&A: What is Difference Between 912 and 921 Bulbs
- Shop: Dutton-Lainson Hand Winch w/ Automatic Brake - TUFFPLATE Finish - Left Side Handle - 1,200 lbs
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer wiring
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Video: Breaking Down the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Suspension Enhancement
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer tires and wheels
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Article: How to Measure for Trailer Hitch Drop
- Shop: Brake Controller
- Search Results: spare tire mount
- Search Results: rv air conditioners
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional





