Troubleshooting Wobble with Swagman XC Bike Rack
Updated 05/14/2018 | Published 05/11/2018
Products Featured in This Question
Question:
The receiver bar fits into the receiver just fine. Very snug. However, the part that holds the bike attached to the receiver bar wobbles. I did the following: Tighten the two set-screws to secure the receiver bar tight against the square section. It wobbles. Any suggestions as to how I can fix this? I can try to over tighten the set screws to see if that works. Thanks Swagman XC
asked by: Bob G
Expert Reply:
For your Swagman XC 2-Bike Rack Platform Style # S64650, the hitch pin that came with the rack or the Anti-Rattle Hitch Lock and Cable # S64031 may need to be tightened. I recommend moving the rack up and down slightly as you tighten that threaded bolt. That should secure the shank to your hitch.
The two set-screws you mentioned connecting the crossbar to the shank, will only tighten so much and you do want to be careful not to strip the threads. If you have wobble of bikes side to side, you may need to adjust your wheel hoops to ensure your bikes are better balanced on the rack. Unfortunately the remaining wobble will remain based on the design of the rack, so other than using Loctite Threadlocker like # LT37420 on the bolts to secure them so they don't rattle loose, there isn't much more you can do other that adding a stability strap like # 18050. I've attached a video to assist.
Product Page this Question was Asked From
Swagman XC2 Bike Rack for 2 bikes - 1-1/4" and 2" Hitches - Frame Mount
- Hitch Bike Racks
- Platform Rack
- Folding Rack
- Frame Mount
- Locks Not Included
- 2 Bikes
- Class 2
- Class 3
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Fits 1-1/4 and 2 Inch Hitch
- Swagman
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Shop: Swagman XC2 Bike Rack for 2 bikes - 1-1/4" and 2" Hitches - Frame Mount
- Shop: Trailer Hitch
- Video: Mount: Curt Trailer Hitch Receiver on a 2018 Subaru Outback Wagon
- Q&A: How do I Keep my Swagman Bike Rack From Wobbling
- Shop: Replacement Threaded Hitch Pin and Clip for 1-1/4" Shanks on Swagman Bike Carriers
- Search Results: hitch wiring harness
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Anti-Rattle Hitch Lock and Cable for Swagman Bike Racks w/ 1-1/4" & Combo Shanks - 7'
- Video: Fit Test: Swagman XC2 Bike Rack for 2 bikes on a 2016 Honda Pilot
- Shop: Trailer Wiring
- Video: Comprehensive Review: Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories
- Q&A: Anti-Rattle Device and Trailer Hitch Lock for Swagman S63400 2 Bike Carrier
- Shop: Replacement Threaded Hitch Pin and Clip for 2" Shanks on Swagman Bike Carriers
- Shop: Replacement Hitch Bolt for Yakima HoldUp 2, OnRamp, and BigHorn Bike Racks and DryDock Canoe Carrier
- Video: Review of CURT Custom Fit Vehicle Wiring - T Connector Vehicle Wiring Harness 4 Pole Flat - C32MJ
- Video: A Closer Look at the Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks
- Video: Swagman Bike Locks - Cable Lock - S64031 Review
- Video: DIY Install: Swagman XC2 Bike Rack for 2 bikes on your 2022 Honda Pilot
- Q&A: Curt VS Draw-Tite Hidden Cross Tube Trailer Hitch Receivers For a 2018 Subaru Outback
- Search Results: track order
- Search Results: swagman bike rack
- Search Results: swagman xc2
- Q&A: Recommended Trailer Hitch for 2021 Honda Pilot AWD
- Q&A: Recommended Shank Insert And Locking Hitch Pin For Swagman Hitch Mounted Bike Carrier
- Q&A: Threaded Hitch Pin for Swagman XC 2 Bike Rack
- Search Results: cargo box lift
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Hitch Bike Racks
