Modification of MaxxHaul Heavy Duty Headache Rack MT70234 for Light Bar Installation
Updated 04/10/2018 | Published 04/07/2018
Question:
Was wondering if I could cut off the load stops on top of the rack to install a bar light on top of this.i will enclose some pics of bar light as well
asked by: Bryan W
Expert Reply:
The MaxxTow MaxxHaul Heavy Duty Headache Rack # MT70234 does have 2 x 2-inch square steel tube construction so the top horizontal surface could well be used as a mounting point for some lights. Of course, the modification needed - cutting off the vertical load stops on each end and drilling holes for your light bar - would void the item warranty. You would also want to be sure to close off those openings so water cannot enter and cause corrosion/rust. RTV sealant # LT37467 will provide a good seal.
You can refer to the linked diagram for measurements of this item that will make it easier to determine compatibility with the mounting of your light bar. That light bar's installation hardware does not appear in the photo so you'll want to check that a 2-inch flat surface will be adequate to secure it.
Product Page this Question was Asked From
Loctite RTV 598 High-Performance Silicone Gasket Maker - Black - 2.7-Fl Oz Tube
- Lubricants Sealants Adhesives
- Sealant
- Gasket Maker
- 2.7 oz
- Loctite
more information >
Continue Researching
- Shop: Suspension Enhancement
- Shop: UTV Tops
- Q&A: How to Choose the Correct Timbren Rear Suspension Enhancement for a 2019 Ram 1500
- Q&A: Comparing Timbren Rear Suspension Enhancement Options For 2020 Ram 1500
- Q&A: Height of Timbren TDRTT1500 that Fits 2019 Ram 1500 and Could it Fit Lowered Truck
- Shop: Timbren Rear Suspension Enhancement System
- Shop: Classic Accessories All-Weather UTV Cab Enclosure - Kawasaki Teryx - Black
- Shop: Timbren Suspension Enhancement System - Severe Service - Rear Axle
- Shop: Coil SumoSprings Custom Helper Springs for Coil Spring Suspension - Front Axle
- Video: Choosing the Right Vehicle Suspension Upgrades
- Video: What to Know About the Timbren Rear Suspension Enhancement System-TDR1500DS
- Video: An In-Depth Look at the Timbren Rear Suspension Enhancement System-TDR1500DS
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer wiring
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Shop: Power Mountain Tallboy Off-Road Bottle Jack - 8-1/2" to 37-3/4" Lift - 6 Tons
- Search Results: suspension enhancement
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller
- Article: How to Measure Your Trailer Wheel Bolt Pattern
on Lubricants Sealants Adhesives
