Best LED Replacement Light for a Truck-Lite Model 60

Question

Question:

I have a 1995 Ranger and one of the trailer lights just now went out. I’d love to replace it with the same thing only in LED cause it lasted so long. Also my trailer has been cut out for it. It says Trucklite model 60 on it. I also have a picture of you need it. Can you help me find an equivalent replacement on your site? Thanks!

asked by: Cory N

1

Helpful Expert Reply:

We have had some other customers inquire about replacing Truck-Lite model 60 lights before and have found that the Optronics Trailer Tail Light # STL72RB is a great LED replacement. For a grommet use part # A70GB and for a pigtail use part # A45PB.

This tail light has the following dimensions 6-7/16" L x 2-5/16" W x 1-3/4" D which you can see in the attached photo.

I have also linked an installation video for you to reference.

expert reply by: Jon G

1

click to enlarge

Answer 1

Based on the dimensions for the Truck Lite Model 60 that you have it matches the Optronics 10-LED Trailer Tail Light #STL72RB so this light will work as a replacement for you. The 48-LED version #STL70RB that you referenced is the same size and will…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Linda, Yep, it sure will; the WeatherTech Roll Up SunShade Kit #WT87QV will indeed fit your 2024 Nexus Viper 27V. This is a good choice as it is double-sided with one reflective side to keep the sun (and heat!) out of your motorhome, with the…

view full answer...

Answer 9

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 10

It looks like you ordered both from us today to use with your Carrier lower vent assembly. The heat strip will work with the Advent but if I am being perfectly honest a lot of times these mixed brand AC Unit solutions don't work as consistently…

view full answer...

Best LED Replacement Light for a Truck-Lite Model 60

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching