Replacement Anti-Rattle Hitch Lock For a Swagman G10 Bike Rack

Question

Question:

I have a Swagman G10 and my vehicle has a 2 inch trailer receiver. My G10 came with the 2inch adapter SP323 but im missing the receiver and hitch pin. My vehicle receiver hitch pin slot is a 5/8. Which Swagman receiver and hitch pins do I need to install my bike rack?

asked by: Mario

0

Expert Reply:

The Swagman Locking Anti-Rattle threaded Hitch Pin, # S64027, will replace the hitch pin for your Swagman G10.

This locking pin has a pin diameter of 5/8 of an inch and will include a set of two keys for the lock cylinder.

expert reply by: Jared P

0

Answer 1

I do have a solution for you. The Replacement Threaded Hitch Pin and Clip for 1-1/4" Shanks on Swagman Bike Carriers, part #P5902, is the replacement bolt you need. The Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks, part…

view full answer...

Answer 2

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 3

I reached out to the manufacturer, Swagman, concerning the fit of the Replacement Receiver Insert for Swagman Bike Racks - Hitch End #P313 on your Swagman Jackknife Bike Rack and was told it would work for your 1-1/4 inch hollow shank. Specifically,…

view full answer...

Answer 4

Yes, the correct nut insert for your Swagman XC part #S64650 that you referenced is the part #P313 that you referenced.

view full answer...

Answer 5

You will need the Replacement Body for Yakima HitchLock #8820048 to fit the Anti-Rattle Hitch Bolt #Y52FR on your Yakima Exo System #Y82VR. You will be able to insert one of your Yakima SKS lock cores into the new hitch lock. If you do not have one…

view full answer...

Answer 6

For the Swagman Chinook the correct replacement hitch insert is the part #P313. The one you referenced fits other racks.

view full answer...

Answer 7

The u-bolt in the Replacement U-Bolt Assembly for Yakima LockNLoad Platforms and TopWater Fishing Rod #Y27CR is made from stainless steel and will use a 10mm nut. We also have the corresponding replacement knobs #Y89CR if you wanted to use those…

view full answer...

Answer 8

I went out to our warehouse and took some measurements for you. The #P313 Replacement Receiver Insert measures 1.31 in x 0.87 in while #P333 measures a bit smaller at 1.30 in x 0.75 in. See the attached images. #P313 is designed to replace the…

view full answer...

Answer 9

I can help you out with the correct lock for the Swagman XTC-2 TILT 2-Bike Platform Rack #S64671. Since this bike rack is a fit for both 1-1/4" and 2" trailer hitch receivers, the correct lock is the Locking Anti-Rattle, Threaded Hitch Pin…

view full answer...

Replacement Anti-Rattle Hitch Lock For a Swagman G10 Bike Rack

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching