What Size is the Drive Nut on the Scissor Stabilizer Jacks # TJSCHD-24

Updated 06/17/2025 | Published 06/05/2017

Question:

Is the jacks drive nut a 3/4? Want to buy the drill drive socket for the jacks im going to order. Want to make sure it will fit the jacks.

asked by: Paul S

Expert Reply:

I went out to the warehouse to measure the drive nut on the Scissor Stabilizer Jacks # TJSCHD-24. From wrench flat to wrench flat it is 0.72 inches so just a hair under 3/4 inch and just a hair above 18mm.

expert reply by: Michael H

Larry C.

6/14/2025

What is the thread pitch on the scissor jack rod?

Kate F.

6/16/2025

@LarryC Our Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 5,000 lbs - Qty 2 # TJSCHD-24 uses a 1/2"-10 ACME thread pitch. Is that going to work for you?

Larry C.

6/17/2025

@KateF Thank you