Is There Fascia Trimming Required to Install Curt and etrailer Hitch on 2016 Toyota RAV4
Updated 03/02/2017 | Published 03/01/2017
Products Featured in This Question
Question:
The etrailer hitch indicates that removal or cutting of body panels is required, but the Curt hitch does not indicate this. It is not clear from the photos which is the case. Can you clarify what is necessary to install these two hitches? Also, what is the bar height or the ball height with a straight bar of these hitches on the 2016 RAV4 Hybrid?
asked by: Michael
Expert Reply:
I checked out both sets of install instructions for the hitches you mentioned. The etrailer part # e98864 and the Curt hitch part # C13149, and for both you have to remove a lower fascia panel (if present). They call it an appearance panel and you can either trim it and replace it or just leave it off, but aside from that there is no fascia trimming at all.
We installed both of these hitches on the same vehicle and found that from the top of the hitch opening down to the ground measured 13 inches so they have the same height.
I attached a help article that covers how to pick out the correct rise/drop ball mount for you to check out as well.
Product Page this Question was Asked From
etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 525 lbs WD TW
- Visible Cross Tube
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Trailer Wiring
- Q&A: Best Ground Clearance with Trailer Hitch for 2015 Toyota RAV4
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Comparing Curt Hitches for a 2017 Toyota RAV4
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Search Results: trailer wiring
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Curt Powered Tail Light Converter Installation - 2023 Kia Telluride
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Suspension Enhancement
- Search Results: trailer tires and wheels
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: Installing the Curt Trailer Hitch Receiver on a 2025 Toyota RAV4
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: How to Measure for Trailer Hitch Drop
- Shop: Brake Controller
- Q&A: Comparing the Curt Hitch C13416 and EcoHitch Hitch 306-X7396 for a 2019 Toyota RAV4
- Search Results: trailer hitch ball mount
- Search Results: trailer jack
on Trailer Hitch
