Availability of Self-Tapping Screws

Question

Question:

Do you sell the self tapping button head screws commonly found on the exterior of enclosed trailers? Thanks.

asked by: Andrew

0

Expert Reply:

We offer two sizes of self-tapping button- (or washer-) head screws. Part # FA1131822 has an unslotted hex head and is 1/4 -14 x 3/4-inch long threads. Part # 101131802 is # 8 x 1/2-inch long.

expert reply by: Adam R

0

Answer 1

Since your 2022 Sunray Classic 149 is a little over 16 feet long the storage cover you would want is the Classic Accessories Deluxe PolyPro III part #CA80198 which is the correct size, is shaped to fit your style of trailer, and offers heavy duty…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hi Steve; the factory hitch on the 2013 Tacoma has the bumper brackets integrated into the hitch. You can replace it with the etrailer Trailer Hitch #e98850 but you will have to remove the old hitch and find new bumper brackets to complete the…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

Both the Curt Class III Trailer Hitch #13323 and the Draw-Tite Class III Trailer Hitch #75236 would work well for you. These Class III trailer hitches have a 2 inch receiver, 5,000 pound max towing weight and 500 pound max tongue weight. For…

view full answer...

Answer 11

Hey Michael, congrats on your new camper. I have a solution for you but we do not have a simple 7-way adapter that is compatible with Lance's proprietary 6-pin plug. What I recommend doing is replacing your Lance 6-pin connector and rewiring it…

view full answer...

Availability of Self-Tapping Screws

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching