Distance Between Mounting Holes of B and W Hitch BWHDRH25124

Question

Question:

I need the dimensions of the mounting holes for the BWHDRH25124 hitch. My concern is, I have a 1995 K1500 GMC with a flat bed, The frame appears to measure 37inch outside to outside. Is this hitch wide enough, I need the width between mounting holes. Thanks

asked by: Shane M

0

Expert Reply:

I was able to get the distance between the mounting holes from left to right for the B and W part # BWHDRH25124 and they are right at 34-1/2 inches.

expert reply by: Jameson C

0

Answer 1

I spoke with my contact at B and W and he informed me that the center section of the B and W Hitch part #BWHDRH25124 measures 31-13/16 inches long measured from outside of flange to outside of flange.

view full answer...

Answer 2

From the top of the mounting plates to the top of the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25124 receiver is a 5-1/4" drop and then from the rearmost bolt hole to the end of the receiver is 10-7/8" (see attached).

view full answer...

Answer 3

Hi Eric, I believe the 1992 GMC Sierra K1500 Z71 came with the step bumper and that's what you're referring to, and while there is a hitch for this truck, there isn't one that is side-mounted which fits. The highest quality hitch for your…

view full answer...

Answer 4

Hello Amy, We have a hitch that’s going to get the job done, though it’s not a Reese brand. I’m assuming you have the standard step bumper on your 1996 GMC Pickup, since you didn’t mention otherwise. In that case, you’ll want the B&W Heavy-Duty…

view full answer...

Answer 5

The B and W Hitch part #BWHDRH25122 would fit your 1995 Chevy Silverado 3500 if it was built on a cab and chassis model. Which easy way to determine this is to measure the truck frame from outside to outside. If this measurement is 34 inches then you…

view full answer...

Answer 6

We have a Class IV that does fit a 1997 Chevy Suburban but it is not the B and W you mentioned. Instead you'd want the Curt hitch part #C14029 which is a confirmed fit and would work well. This has a 10,000 lb towing capacity which would be more…

view full answer...

Answer 7

The fit depends on what cab you have on your 1989 Chevy C1500. For Crew Cab models you need the Curt Trailer Hitch Receiver #C14082. For non-Crew Cab models you need the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25124.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Distance Between Mounting Holes of B and W Hitch BWHDRH25124

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching