How Could Jack Handle be Secured to Jack Body so that it Stays Horizontal When Stored
Updated 08/15/2016 | Published 08/13/2016
Products Featured in This Question
Question:
How do you keep crank handle in horizontal Position Do not want handle to face towards ground
asked by: Cary
Expert Reply:
Sounds like you are looking for a way to keep the handle of the Dutton Lainson jack part # DL22580 horizontal when the jack is in the horizontal, stored position. Most likely you want to this so the handle doesn't drag.
This isn't a super common situation so there isn't a specific solution for this but what you can do is use a strap like the part # EM06701 to basically strap the handle to the main body of the jack so that it wouldn't turn down.
Product Page this Question was Asked From
Pull Pin, Easy Swivel Trailer Jack with 6" Dual Wheels - Sidewind - 1,500 lbs.
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 1001 - 2000 lbs
- Manual Jack
- 12 Inch Lift
- Bolt-On
- With Wheel
- Dutton-Lainson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Jack for Ranger Boat Trailer With Dutton Lainson 203960C
- Q&A: Dimensions of Dutton-Lainson Round Swivel Jack DL22335
- Q&A: Who Manufactures etrailer Round/Wheeled Swivel Jack
- Q&A: Trailer Jacks Manufactured in the USA
- Q&A: Trailer Valet JXS Drill Powered Swivel Trailer Jack TV76FR Measurements
- Article: Best Boat Trailer Jacks
- Article: Most Popular Wheel Bearings
- Q&A: How Much More Clearance Under Trailer Using Torsion Axle With Negative Angle
- Q&A: Acceptable Range of Spindle Deflection on Torsion Axle
- Article: Trailer Maintenance Schedule
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation on a Ford Full-Size Van