Landing Gear Recommendation for 2010 Jayco Designer 35 RLTS
Published 08/09/2016
Question:
I have a 2010 jayco designer 35 rlts 5th wheel. I need new landing gear. The tubes are flat on top and measure 36 1/2inch with 15 1/2inch between blocks. I cant find a replacement anywhere. HELP
asked by: Paul H
0
Expert Reply:
The standard measurement on landing gear legs is 15-1/2 inches between the tabs that are on the actual legs like what you have.
The etrailer Landing Gear Set, part # RVLG-8000 can be used to replace the landing gear set you have on your 2010 Jayco Designer as it fits the standard dimensions you have.
expert reply by:
Jameson C
0
click to enlarge
Continue Researching
- Search Results: landing gear camper jacks
- Q&A: Solution for Atwood Landing Gear Jack that Has Damaged Leg
- Search Results: landing gear trailer jack
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Q&A: Powered Landing Gear Recommendation for Trailer Weighing 14,000 lbs
- Search Results: trailer jack
- Search Results: landing gear
- Q&A: Replacement Lead and Follow Landing Gear Legs to Replace 71488 on 2012 Jayco
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Search Results: front landing gear
- Shop: Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear
- Shop: Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Shop: Replacement Bearing for etrailer and Ram Round, Sidewind Jacks - 2,000 lbs and 5,000 lbs
- Q&A: Replacement Jack Legs for Venture VMC900R Landing Gear
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Lippert Electric Landing Gear w/ Handle - Inside Mount - 34-3/4" Lift - 5,000-lbs
- Q&A: What is the Difference Between the MORryde CRE3000 and AllTrek 4000 Suspension Kits
- Q&A: Can Inner leg be Removed From Out Leg Of Lippert Landing Gear On Fifth Wheel Trailer
- Q&A: Could Ultra Fab Dual Motor Landing Gear Replace Lippert Landing Gear
- Article: Trailer Maintenance Schedule