Is The Weight Capacity Of A Landing Gear The Capacity Of The Jacks Or The Max GVWR Of The Trailer
Updated 02/22/2023 | Published 02/21/2023 >
Question:
What is the travel speed extension and retraction of the jack legs? Does the 6000lb lift rating refer to the total weight that can be lifted, or the maximum weight of the trailer assuming most of the weight will pivot on the axle? Finally, how much does the entire kit weigh?
asked by: Michael H
Helpful Expert Reply:
The 6,000lb rating of the Lippert Electric Landing Gear Set # LC333964 is the combined weight capacity of the jacks (i.e each jack can support up to 3,000lbs of weight). This is pretty typical since it's only supporting a fraction of the weight, with the majority on the axle(s). It weighs approximately 73lbs.
As for the travel speed, I reached out to Lippert but was unable to get a specific speed rating from them and we haven't had an opportunity to test this landing gear while under a load to determine a speed rating ourselves.
Product Page this Question was Asked From
Lippert Electric Landing Gear Set - 37" Lift - 6,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 5001 - 6000 lbs
- Electric Jack
- 37 Inch Lift
- Weld-On
- 2 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: landing gear camper jacks
- Search Results: landing gear trailer jack
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Replacement Lead Leg for Venture 5th Wheel RV Landing Gear
- Q&A: Powered Landing Gear Recommendation for Trailer Weighing 14,000 lbs
- Shop: Landing Gear Set w/ Handle - 36-1/2" Lift - 8,000 lbs
- Shop: Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Shop: Replacement Rod and Nut for etrailer and Ram Square, Direct Weld Jacks - 12K
- Q&A: Landing Gear Recommendation for 2010 Jayco Designer 35 RLTS
- Q&A: Replacement Jack Legs for Venture VMC900R Landing Gear
- Q&A: How to Determine Correct Replacement Landing Gear
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Replacement Landing Gear Follow Leg for 2003 Keystone Everest
- Q&A: Determining if Replacement Landing Gear Set Will Mount to Existing Brackets on Trailer
- Article: Trailer Jacks
- Article: Best Landing Gear
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Measure for Motorhome Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps


