Dimensions of Draw Tite Hitch 24928 For a 2016 Ford Mustang

Updated 06/23/2016 | Published 06/15/2016

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(56)

$283.94

Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(74)

$270.55

Question:

Do you have drawings with dimensions that you could send me for these two trailer hitches? Curt #C11405 and DrawTite #24928 The three main dimensions that would help are the distances from: 1 inside of verticle to frame mtg. plate -to- inside of lower vert. plate that round Xtube mounts. to. 2 top of horizontal to frame plate -to- top of Xtube where it is welded to the verticle plate. 3 top of horizontal to frame plate -to- top of tube after it curves down and goes level across to center. Also, what is the extra tab on DrawTite that says for accessories? I have custom exhaust branch resonators that mount inboard of and next to the mufflers, so I need to check fitment.

asked by: Dave

Expert Reply:

I spoke with my contacts at Curt and Draw Tite to track down the dimensions you requested. I was able to get a dimensional drawing from Draw Tite that has what you asked about plus more as well.

For the Curt they state that the first dimension you are looking for is 7.6 inches, the second 5.1 inches and the third 7.2 inches. Looking at the picture of the Draw Tite it looks to be 8.4 inches, 6.96 inches, and 7.273 inches.

Hopefully the diagram helps explain the dimensions better as it was somewhat hard to determine what you were asking for.

There isn't a tab on the Draw Tite hitch for accessories. My contact at Draw Tite wasn't sure what you referred to either.

expert reply by: Jameson C