Need Trailer Wiring to Use on 2008 Toyota Corolla and Fold-Up Trailer Kit
Published 09/02/2010
Products Featured in This Question
Question:
Hello, I have a harbor freight fold-up trailer kit that I have just assembled and now I need the wiring to the car. The car is a 2008 Toyota Corolla. The lights on the trailer are a combination taillight/stoplight/turn signal on each side and a smaller amber colored light on the trailer frame towards the front. Is your adapter wiring really plug and play for my car and trailer? Im not very good at figuring electrical stuff out. Thanks.
asked by: Jim
Expert Reply:
We have a custom fit vehicle wiring for your vehicle. I used the Fit Guide on the website and found that the wiring kit you need for your 2008 Toyota Corolla is the Curt Custom Fit Vehicle Wiring, part # 55542. This kit will wire into the vehicle wiring and allow you to connect your trailer to your 2009 Toyota Corolla.
Yes, this custom fit wiring simply plugs into your factory wiring harness, it is a plug and play kit.
When connecting the trailer wiring to your vehicle it is always a good idea to use some dielectric grease, part # 11755, in the connector to prevent corrosion.
I have linked instructions below for the Curt Custom Fit Vehicle Wiring, part # 55542.
Product Page this Question was Asked From
LED Combination Tail Light Kit for Trailers under 80" Wide - Submersible - Driver and Passenger
- Trailer Lights
- Tail Lights
- License Plate
- Rear Reflector
- Side Reflector
- Stop
- Tail
- Turn
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 5L x 5W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Does etrailer Trailer Hitch Receiver for 2018 Dodge Journey Include Fishwire
- Q&A: Will A Spare Tire With A Higher Load Rating Be Ok On A 2022 Aluma 7814ST?
- Q&A: How Does the Submersible, Under 80" LED Trailer Light Kit part # TLL9RK Wire to Trailer
- Q&A: How Do I Measure To Find The Correct Bolt Pattern For My Wheel?
- Q&A: Parts Needed To Switch Trailer From Standard Ball Coupler To Pintle Hitch System
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Availability Of 2-5/16" A-Frame Coupler With Holes That Match Bulldog BD43805W0317
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Dexstar Trailer Wheel with 17-231 Sticker