Tips for Finding Keyed Power Source for Install of Air Lift WirelessONE Compressor # AL25870

Updated 02/01/2016 | Published 01/31/2016

Question:

I have a 2012 Dodge Ram 3500 Laramie with the 6.7L Diesel. I am trying to install the compressor but the fuse box is a very tightly sealed under the hood and would leave no room for the recommended installation procedure. Looking for other options.

asked by: Robert S

Expert Reply:

For the 12 volt keyed power source for installing the Air Lift WirelessONE Compressor # AL25980 you don't have to go to the fuse box if you don't have the ability to. You just need to find a wire that carries 12 volts only when the key of the vehicle is on.

Typically wires that run to the radio can work since that only comes on when the key is on, or you can use ignition related circuits (be careful here), or even traction control or power antenna. Another way to find the circuit is look for a light or accessory in the vehicle that lights up when the key is on and go with that.

expert reply by: Jameson C