How to Wire a 2015 Ford Edge SEL to be Dinghy Towed
Published 11/30/2015
Question:
I recently purchased the RM-154 kit and cannot figure out how to get it wired correctly. I can get the LED side marker taillights to work but cannot get the rear LED taillights to work with the diodes.
asked by: James
Expert Reply:
Dinghy wiring the 2015 Ford Edge SEL model is quite a bit different than normal diode wiring because Ford combined the stop, turn and taillight signal on the same wire that goes to the rear facing LEDs in the taillight.
To make the # RM-154 kit diodes work properly you will need 2 resistors rated for 50 ohms and 10 watts for LED tail lights or 2 rated for 5 ohms and 10 watts for incandescent tail lights, available from a local electronics supply store. You will also need to wire the diodes differently to get the LED taillights to work properly. I have attached a diagram showing how to wire in the resistors and the diodes.
We did a flat tow setup on a 2015 Ford Edge SEL here and found that the correct wire to splice into was the darker brown wire which is most likely the same wire you used that only illuminated the side marker lights in the rear taillight housing. Using this new diagram you will get the rear taillights to work properly.
Product Page this Question was Asked From
Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 4-Way Flat Connectors
- Flat Tow Wiring Harness
- Splices into Vehicle Wiring
- Diode Kit
- Universal Fit
- 4 Flat
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Vehicle Tow Bar Wiring
- Shop: Demco Air Force One Air Jumper for Freightliner BrakeSync-Equipped Chassis
- Shop: Vehicle Tow Bar Brake System
- Search Results: trailer wiring
- Search Results: tail light converter
- Search Results: demco air hose
- Search Results: diode
- Shop: Replacement 6-Amp Diode for Blue Ox Tow Bar Wiring Kit
- Shop: Replacement Roadmaster Smart Diode for LED Tail Lights - Qty 1
- Shop: Blue Ox Block Diode Tail Light Wiring Kit for Towed Vehicles
- Video: Demco SBS Air Force One Coach Air Kit Installation - 2018 Newmar Ventana Motorhome
- Video: Review of Demco Air Force One Coiled BrakeSync Air Jumper Kit - DM97ZR
- Shop: Trailer Wiring
- Q&A: Does Demco SBS Air Force One Coiled Air Jumper Kit Work With 2022 Newmar Dutch Star
- Q&A: Part Needed To Be Able To Use BrakeSync On A 2022 Fleetwood Discovery With A Towed Vehicle
- Q&A: Demco Air Force One Compatibility With A 2022 Newmar Dutch Star On A Spartan K2 Chassis
- Shop: Replacement Male Quick Disconnect for Demco SBS Air Force One Supplemental Braking System
- Shop: Replacement Air Jumper for Roadmaster BrakeMaster Flat Tow Brake System
- Shop: Replacement Quick Disconnect Kit for Roadmaster BrakeMaster Flat Tow Brake System
- Search Results: rock guard tow protector
- Shop: Trailer Hitch
- Video: An In-Depth Look at the Roadmaster Battery Charge Line Kit for Towed Vehicles
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
on Flat Tow Wiring Harness
