Recommended Replacement LED Lights For Trailer That Keeps Blowing Fuses
Published 08/14/2015 >
Products Featured in This Question
Question:
Is it possible to replace the 10 amp fuse with a 15 amp fuse? I think that the trailer Im using draws more than 10 amps when I push the brakes. It works fine with indicator lights and flashers, but when I push the brake I blow the fuse after about 1-2 seconds. It has 4 ST9RB lights, that I think draw 2.5 amps each under braking condition, then a few other lights that probably put me over the top. Will the 15 amp draw harm anything else in the wiring circuit?
asked by: Steve G
Expert Reply:
The wires with the circuit you are using are not big enough to handle the draw you have so increasing the fuse is not recommended.
I recommend replacing the lights you have with LEDs. The replacement for the # ST9RB lights you have now would be part # STL9RB. These draw about 1/10 of the amperage draw the # ST9RB does. This would decrease the draw on your system and a larger fuse would not be needed.
Occasionally when LED lights are installed you will have what is called hyperflash, and the lights will flicker. If that does happen you can install a LED Light Bulb Load-Resistor Kit, part # DI34ZR, to each light socket that has an LED bulb and flashes.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Universal Magnetic Tow Lights - Red LEDs - 20' Wiring Harness with 4-Way Flat Trailer Connector
- Shop: Trailer Hitch
- Shop: Vehicle Tow Bar Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Search Results: trailer wiring
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Video: Feature Breakdown: Universal Installation Kit for Trailer Brake Controller
- Shop: Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 7-Way to 6-Way Coiled Adapter Cord
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Suspension Enhancement
- Search Results: trailer jack
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: How to Measure for Trailer Hitch Drop
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Video: An In-Depth Look at the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit
- Shop: Base Plate for Tow Bar

