Will Draw-Tite Class III Hitch # 41946 Fit a Motorhome on 2005 Chevy Express 3500 Cutaway Chassis

Published 02/05/2015

Products Featured in This Question

Draw-Tite Ultra Frame Trailer Hitch Receiver w/ Cast Center - Custom Fit - Class V - 2"

(113)

$281.40

Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"

(46)

$236.78

Question:

Can I get measurements of hitch? Will it fit 2005 Chevy express 3500 motorhome?

asked by: Zahn

Expert Reply:

The Draw-Tite Class III hitch you mentioned, part # 41946 will fit a 2005 Chevy Express, but I couldn't say if it'll fit a motorhome on a cutaway van chassis. Usually the rear bumper structure at the rear of a motorhome is much different that it would be if the vehicle was finished as a van. If you look at the photo I've provided, you can see the relevant measurements.

The side to side distance between the bolt holes measured center hole to center hole is 40-11/64 inches. The drop (distance from top of hitch mounting flange to top of the receiver tube) is about 1-1/2 inches.

If the measurements of the hitch are consistent with center to center frame hole distance and drop needed on your motorhome, the # 41946 hitch would work fine.

If the # 41946 won't fit, a weld-on hitch like # 41990-07 would be a good alternative.