How Wide is Draw-Tite Trailer Hitch 41904 for a 1982 Ford F-350

Question

Question:

Need to know the width on hitch #41904 i have a 1982 ford f350 without bumper so i am not needing any my frame is 37 1/4 wide

asked by: Chris

0

Expert Reply:

I went out to the warehouse to measure Draw-Tite trailer hitch # 41904. From the center of one mounting hole to the center of the one on the opposite side is 35 inches. This means that it will fit the pickup models that have the 37-1/4 inch wide frame but not cab and chassis models with the narrow 34 inch frame.

expert reply by: Michael H

0

click to enlarge

Answer 1

The etrailer.com Trailer Hitch #E98861 will fit your 1997 GMC Savana so long as it is a cargo or passenger van model; if you take a look at the photo of the dimensions of this hitch you can see that the bolt holes are also 40" apart like you…

view full answer...

Answer 2

The Draw-Tite Class III hitch you mentioned, part #41946 will fit a 2005 Chevy Express, but I couldn't say if it'll fit a motorhome on a cutaway van chassis. Usually the rear bumper structure at the rear of a motorhome is much different that…

view full answer...

Answer 3

Your 2012 Express Shuttle Bus would be built on the cutaway chassis version of the 2012 Express Van so that means the correct hitch you'd need is the Buyers Products part #3371801102 which was made for this style of chassis. I attached a picture…

view full answer...

Answer 4

The Curt #C15320 will fit the frame of your 2014 Chevy Express Cutaway Van Chassis, but in order for the hitch to clear the bumper, the distance between the underside of the frame member that the hitch bolts to and the lowest point of the rear bumper…

view full answer...

Answer 5

I can get you set up with everything you need for your 2016 Chevy Express Van. The hitch I recommend is the Draw-Tite Ultra Frame #41946, a Class V hitch with a maximum tongue weight of 1,500 lbs and maximum towing capacity of 10,000 lbs. You can…

view full answer...

Answer 6

The hole centers for the Buyers Products 2" Hitch Receiver #3371801102 are 39-1/4" from drivers side frame rail to passenger side frame rail. This receiver is confirmed to fit the 2014-2021 Chevrolet/GMC Express/Savana Cutaway Chassis. If…

view full answer...

Answer 7

To confirm if the Curt Trailer Hitch Receiver #C15320 will fit your 2007 GMC Savana bus you will need to check the frame for the correct mounting points to confirm that it will fit. Since the receiver is only confirmed to fit the passenger and cargo…

view full answer...

Answer 8

The Buyers Products 2" Hitch Receiver For GM Express/Savana #3371801100 is designed to fit the standard van chassis with an OEM rear bumper. The top of this hitch will be 2" below the bottom of the frame rails. The Buyers Products 2"…

view full answer...

Answer 9

The distance between the bolt holes on the Curt Trailer Hitch Receiver #14080 is 39-1/4" center-to-center. I have attached a photo to demonstrate this. Please note that this trailer hitch fits the following: 2002 - 2002 Chevrolet Avalanche 2002…

view full answer...

Answer 10

The trailer hitches we have available for the 2014 GMC Savana Van are designed to fit the full size van model. To see if these will fit your Cutaway version, I just recommend taking a couple measurements on the vehicle's frame. The trailer hitch…

view full answer...

Answer 11

Unfortunately that 12 pin rectangular plug has nothing to do with the trailer wiring harness. To add a 7-way and 4-way connector to your 2023 Chevy Express Cargo van you're going to need to buy two separate harnesses. The reason for this is that…

view full answer...

Answer 12

The mounting holes the Curt Trailer Hitch Receiver #14053 measure 38-1/4" and 38-3/4" width-wise and then from the center of the of the forwardmost to the rearmost is 13-1/4". Attached is a dimensional photo for you to reference. This…

view full answer...

How Wide is Draw-Tite Trailer Hitch 41904 for a 1982 Ford F-350

Continue Researching