2001 Ford F-150 Grille

The towing capacity of the 2003 Chevrolet Avalanche 1500 with 5.3L V8 and 4.10 rear axle is 8100-lbs. For a 7600-lb GVWR travel trailer the resulting 500-lb safety margin is adequate/low-ish. With a trailer that weighs substantially more than the tow…

Hey William, We do have a great option for an airbag kit for your 2026 Ford F450. I recommend the Airlift #AL88399 airbags, these offer a 5,000lb load leveling capacity with no drill installation. Depending on what you are towing these also are…

Westin MAX Winch Mounting Tray #46-21245 is a confirmed fit for your 2006 GMC Sierra 2500 HD and it mounts in front of the factory bumper. The linked photo, taken from the install instructions which I've sent to you, shows the finished appearance…

The Center Section #C-52 for the Curt Overbed, Folding Ball Gooseneck Trailer Hitch #C61341-52 is very close to the measurements you provided. I have included an image with the measurements for this as the front to back mounting holes are 9-3/4"…

Since gooseneck and 5th wheel hitch brackets need to match with the hitches themselves, even if your Atwood folding gooseneck hitch fit the Curt rails I couldn't recommend doing so because they have never been tested together. For a similar…

I reached out to my contact at Demco and he said that depending on the year, there was a gear adjustment bolt on the cab side of the base of the older Hijacker models. He also said some of the slide bar heads had an adjustment bolt there as well for…

Yes, the Westin Platinum Series Oval Nerf Bars #21-2315 comes with all the included hardware for a quick and easy bolt-on installation to your 2005 Dodge Ram 1500 quad cab.

Hey David, thanks for reaching out. That is a slick camper. Your 2017 Airstream flying cloud uses a #11 Dexter axle. It uses a #25580 (1.75" inner diameter) inner bearing and #M67048 (1.25" inner diameter) outer bearing. We can provide…

It is frustrating but the rear tie downs for a vehicle from Torklift are based around what type of hitch is present. So if you went with the TorkLift SuperHitch part #TLD1102 on your truck you would need to go with a new rear tie down. You didn't…

Yes, the Edge CTS3 Programmer part #EP39YR that you referenced would fit and work well on your 2011 Chevy Silverado with a 6.0 liter V8. It also will work with the basic modifications you mentioned as well. As long as you don't go beyond what you…

To determine an exact amount of power gains for a 2014 Chevy Silverado 1500 with the 5.3 liter motor it would have to be placed on a Dyno to calculate its new output. When you add performance products to a vehicle, the gains do not necessarily stack.…

I would first check to see if there has been an update for your Superchips Flashpaq F5 Performance Tuner - GM - Gas/Diesel, part #SU2845. If so, you should update your software. Once completed, try the tuning process again. According to Superchips,…