How to Add a Cigarette Lighter Power Source for a Furrion Vision S Monitor

Updated 01/14/2026 | Published 01/07/2026

Products Featured in This Question

Replacement Furrion Monitor Power Cable

(388)

$43.30

12 Volt Outlet Kit, 20 amps

(413)

$43.98

Question:

My Furrion Vision s camera uses this cord C-FOS07TAPK-006. But my truck does not have a cigarette charging port. The truck I nly has usb or type c ports. Does this come in a type c usb?

asked by: John

Expert Reply:

No, it does not John. The only power cord available for the Furrion Vision S monitor is the item # C-FOS07TAPK-006 you have. The only solution I have is for you to install the 12 Volt Outlet Kit, 20 amps item # RM-9332, which will provide you with a cigarette lighter connection.

The Roadmaster item # # RM-9332 is typically wired directly to the battery but you can use the included fuse tap and wire it to a fuse that only has power when your truck is running.

What kind of truck do you have?

You can add this information, along with any other questions you have, where it says Reply to Jerred H.

expert reply by: Jerred H

RM-9332
(click to enlarge)

Joh

1/14/2026

2026 Chevrolet silverado 2500hd ltz

Jerred H.

1/14/2026

@Joh Thanks for the information! You're going to run into another issue once you get the monitor powered. The voltage management system in the new Chevy truck's doesn't provide a consistent enough amount of voltage to power rear camera's. This is a problem with all camera systems not just the Furrions. You're also going to need the 7-Way Vehicle Power Adapter item # FR87PR. This will plug in-line with your Silverado and trailer's 7-way connector. It provides constant power from the 12v pin so the camera/s get a steady amount of voltage. If you don't want to mess with the item # FR87PR every time you tow, you can install the 12V PWM Filter item # VGR64VR behind the camera's. This will wire in directly and provides the same steady amount of power.