Hey Paul, it looks like the OEM springs of your 2021 Ram 2500 are rated for 2,218 lbs per spring whereas the SumoSprings part #SSC-52 are rated for 2,475 lbs.
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
Hey Tim, thanks for reaching out! If you're replacing a GE AC unit, then the GE Appliances Deluxe Plus RV AC #GE64FR will work with your thermostat, but if you're replacing a different brand of AC with this GE, then we'll need to get you…
Hello Jim, Wow, they quoted you seven hours for a trailer hitch install? That seems really high. The EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2" #EH87CR is specifically designed for the Hybrid version of the 2025 Toyota…
Hey Brad, yeah you would need a hitch extender with the Thule ReVert bike rack part #TH83VA to allow the tailgate of a full size truck to open. For that we have the Gen-Y Hitch Extender part #e88YR which is 8 inches long. What kind of bikes will you…
Hey Jack! First of all, congrats and the soon to be new travel trailer! Ideally the correct WDS is going to put your trailer's tongue weight right around the middle. It looks like your trailer comes in at 9,630 lbs, so if we figure 15% of that…
Hey Chris, Our Fitguide can be a bit confusing sometimes. Essentially the whole category is broken down into whether they fit diesel or non-diesel models. Since the EcoHitch Hidden Front Mount Trailer Hitch Receiver #EH37FR fits both gas and diesel…
The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…
The inner diameter of the expanded ends of the part #CAM44812 is 1.53 inches and the outer diameter of the non expanded end is 1.51 inches. So basically this setup is designed to either slip into a 1-1/2 inch pipe or slip over a 1-1/2 inch pipe.
Hi Duane, Air Springs are better for leveling loads and will typically give you a rougher unloaded ride quality so these might not be the best option for your setup depending on what your intended use is. Air springs are the best option when it comes…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
I have attached a drawing from the installation instructions for the rail kit part #C16430-204 you can check out. As you can see in the attached drawing I noted the carriage bolts and where they are located on the rails when installing. Please note…
