Welcome back Michael. The 7-Way Vehicle Power Adapter #FR87PR takes the vehicle’s PWM/insufficient running-light signal and provides a steady 12V supply so Furrion cameras can operate properly. The tow vehicle lights still need to be powered on to…
Hey David, you can replace your Coleman Mach 15 with the Coleman Mach Everest part #CM35MR and use the same wiring that's behind the walls. Everything else would need to be swapped out but the wiring can be reused. We only have the Everest in the…
Hi Toby, At this time, Coleman Mach has not announced a heat pump version of the Mach Everest RV Air Conditioner #CM63MR. The current Mach Everest is marketed as a cooling-only, variable-speed air conditioner, and I have not seen any official…
Hey Kyle! That is correct. The Coleman-Mach Mach-C Everest has variable-speed cooling and an inverter-driven compressor. However, the Mach-C Everest uses a traditional wall thermostat instead of a remote control. It also works with both ducted and…
Hi Ashley! Yes, we do. If you're looking for the PopStep kit that includes the pieces between the steps, you'll want the PopStep, GapGuards, and NightLine Kit for MORryde StepAbove 3 Step, 19-1/2 Inch Treads, Part #PS63UR. This kit includes…
Hey Jason! I'm guessing you have the 12" long shank right now which is the standard. For a longer shank that fits a 2-1/2" receiver you can use the Equal-i-zer Weight Dist Shank - 2-1/2" Hitch - 16" Long - 7" Rise,…
We sure do Bruce and welcome back! The Curt V-5 S0700U-R2 receiver is our Ball Mount item #D-26. The Curt item #D-26 is a 2" ball mount with a 7,500 lbs towing capacity. It provides a 3/4" rise, a 2" drop, and has a 1" diameter…
Hi Glenn, I was able to pull a few specs from your Dexter axle number, it looks like it is a 3.5K EZ-lube axle with 5 on 4 1/2 bolt pattern and a 2 3/8" diameter axle tube. I wasn't able to determine the hub face or spring center measurement…
What is your current tire size? The only tire size I saw mentioned online for a Flagstaff 176LTD is ST145-12 (also commonly referred to as 145/80-12). We do offer that size in a radial as part #AM10130 which is a load range D with a 1220 lb per…
Hey Bob, yes the PopStep for MORryde StepAbove #PS47UR that you referenced does come with 2 steps that are slightly shorter front to back and slightly longer one for the top to match the step sizes on the MORryde StepAbove fold down steps. Are the…
Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…
Hi Eric - yes, that’s completely normal. The Jay Feather Micro sits lower to the ground than many larger travel trailers, so a 2-step Lippert SolidStep setup is typical from the factory. Now just verify tread width before ordering so you don't…
Step rugs add confident footing and help keep grit out of your rig. Built for morryde steps with 3 steps, you'll find options that match 2nd generation triple steps with 17-1/2" wide treads and a wider top step that uses strap slots. Installation is straightforward, and the added traction helps people and pets feel steadier going in and out.
Yes, they add a good non slip grip and can help reduce slips going in and out. They also help keep dirt out of the RV. Pets and folks uneasy on bare steps often gain confidence with the added traction.
Installation is straightforward. Clear directions and strap fasteners make setup quick, with installs taking about 30 minutes. Fit checks help—align the straps with the MORryde slots, center each rug on the tread, and tighten evenly so they stay put.
First, confirm you have the correct size for MORryde 3 Steps and the right generation. Make sure the top rug's straps route into the MORryde slots and are tightened; a wraparound-only rug may not fit the wider top step. If fit seems off by even an inch, recheck tread width and step count before securing again.
Pick a 3-step set designed for MORryde that includes two shorter rugs and a slightly longer top rug. Confirm the top rug uses straps that go into the MORryde slots. If your steps are 2nd generation with 17-1/2" treads, match that width for a better fit.
Yes, look for covers custom fit to MORryde 2nd generation triple steps with 17-1/2" wide treads. Check that the set is made for 3 steps and notes compatibility with the wider top step. Verify the strap style matches the MORryde slots so the top rug can secure without wrapping all the way around.
17-1/2 Inch Wide
19-1/2 Inch Wide
23-1/2 Inch Wide
Filters
