Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…
What I would do is go out to your truck and measure out 71 inches and 65 inches on a tape measure and compare that to the width of your bed. If you think the 71 inch looks better and would suit your needs then…
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
Hey Tanya, thanks for reaching out! To tow your trailer you'll need a ball mount with a 2" rise and for that I recommend going with the etrailer Ball…
Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…
According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their…
So the Rhino-Rack Roof Mounted Steel Cargo Basket #RMCB is their small roof top basket. This basket is 47-3/16" long by 35-3/8" wide and…
The 71" Rhino-Rack Vortex Crossbars for Retrax XR Tonneau Covers item #RRVA180B-RRRLT600 are the correct set for your 2022 Ram 3500. These are made for full size trucks and fit in the rails of the…
Hey Luke; the answer to your question is yes it does! Your 15 x 110 Boost is 100 percent compatible with the Yakima HighSpeed Roof Bike Rack #Y54NJ. The HighSpeed #Y54NJ is as good as it gets for a roof-mounted bike rack; it uses a simple knob to…
Hey Michael, thanks for reaching out! The EcoHitch #EH57FR sits a little higher than the Curt #C52NR so it will give you better ground clearance for your 2024 Chevy Silverado 2500. The EcoHitch is a bit more recessed into the front bumper than the…
Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the…
For your setup I recommend the TrackTowers for Yakima Crossbars and Platforms - Track Mount #Y52AV which includes everything you need to mount Yakima crossbars to your Retrax cover (unless you plan on using the Round or HD bars - then…
(1)
(2)
Filter Results
