Hi Mark, You shouldn't need to use the Furrion 7-Way Vehicle Power Adapter part #FR87PR because your 2018 Ram 2500 is from the fourth generation of the Ram 2500 before they did the huge overhaul that changed the circuits and resulted in the newer…
Hey Arkadius, welcome back! Yes, the ducted version of the Chill Cube comes with a remote. However, you're going to need the complete system for a replacement. You can choose from the following based on color: -Furrion Chill Cube RV Air…
Hey Craig! Is this a Lippert Ground Control system? Is the part actually 304136? I asked Lippert and they said they don't have anything under 304135. If it is the 304136 the correct replacement is the Replacement Control Module for Lippert Ground…
Hey Jerry, does the LED still light up on the front of the Mighty Cord SurgeMinder Surge Protector and Circuit Tester #SU39SR? If it was actually overloaded it would have damaged the internals of it and it wouldn't work as a surge protector any…
Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…
Hey David, it sounds like you know what you're doing but I've also gone ahead and found the wiring diagram for the Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR for you to check out so you can use it as a cross…
Hey Kenny, welcome back! The reason for that note is because all of the new systems since 2025 use R32 refrigerant due to EPA regulations. Any 2024 and older systems use R410A and their parts are not compatible with the R32 units. It doesn't mean…
Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…
Hey Scott. The Furrion Variable Speed Chill Cube RV Air Conditioner w/ Heat Pump like item #FR97TQ in black or item #FR67TQ in white are only available in 18K btu capacities. The Chill Cube uses variable-speed technology, which allows it to reduce…
Hey Steve, yes the Dexter Nev-R-Adjust Brake Assembly set part #23-458-459 is the correct set for your Airstream based on the part numbers you mentioned. Also the hub/drum part #8-388-80UC3 that you referenced as well would be correct for your…
Hey Ken, welcome back! The Chill Cube #FR24TQ is just the rooftop unit. The #FR67TQ is the rooftop unit with the air distribution box (ADB) and the remote. This is everything you need for a complete installation. The #FR59TQ is the AC unit with the…
Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…
Excellent service and I recieved the order in a reasonable time. Thank you and I will definitely be using your company again.
George
Houston, TX
RV Interior Lights with LED Puck Lights
Match your cutout and mounting pattern for a clean swap—an LED light in a puck light style often replaces older RV fixtures with brighter, efficient output. You'll find warm white options, including 3,500 kelvin, and switch styles like solid push buttons or rubber actuators. Confirm wiring polarity and key dimensions like overall diameter, cutout size, and hole spacing to get the fit and look you want.
Yes—connect to 12v and test. If there are no wiring instructions and the light doesn't power on, reverse the polarity of the two leads. For lights with twist-lock lenses, align the tabs carefully and don't force the cover; pressing too hard can snap tabs. Pre-fit the cover before final mounting.
Typically no—lens covers for these LED puck lights aren't sold separately and you'll replace the entire light. Measure your existing light and choose a full replacement with the same mount style and size to keep the look consistent.
Start by matching the mount: recessed lights need a cutout match, surface-mount lights need screw-hole alignment. Measure your light's overall diameter, the cutout (if recessed), and the mounting hole spacing. Expect minor differences—some replacements can be slightly smaller than OE and holes may not line up perfectly, so verify before drilling.
Look for warm white listed at 3,500 kelvin if you want that softer tone. This has been a good match with other stock lights in RVs. Check the spec label for the kelvin rating to confirm it matches what you prefer.
A solid push-button switch is a popular choice and can be less likely to fail than a slide switch. If your current rubber push style sticks, consider swapping to a hard button. Verify the switch type in the description or photos so it matches what you want over beds or tables.
Filters
