Hey Jerry, thanks for reaching out. The Atlas IV Hydraulic Trailer Jack #ST23FR is a single-acting hydraulic jack, so hydraulic pressure is only used to extend the cylinder. Once the trailer is coupled and the tongue weight is off the jack, the…
The side plates in the Curt Class 5 Universal Weld-on Hitch #C87CR have only been tested by Curt in the vertical position. With that they are not sure how the mounting brackets will hold up if mounted horizontally. I recommend the Buyers Products…
While we don't have that style of door latch kit, I do have a solution for you with the Cam-Action Lockable Door Latch Kit #PLR258-002 which comes with everything but the bar which is looks like you already have. I haven't seen that type of…
I have a solution for you but you will need to supply your own pipe to get your desired 33-1/4 inch size. The Universal cam-door lock with 1 inch keeper #383200 will allow you to create a bar lock assembly of 33-1/4 inches. With this item you supply…
The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…
Hey Garry, thanks for reaching out! The Peterson Clearance or Side Marker Trailer Light w/ Reflector #422800 measure 4-1/16" long x 2-1/16" tall x 1" thick and have 3" mounting hole centers so as long as this matches what you have…
Dexter recommends that you check the wires of the brake assemblies of your trailer to determine which magnet would be what you would need. If the wires are white you would need part #BP01-265 and if they are yellow part #BP01-301. However, aside from…
No, they're not the same. The BP01-301 fits 12-1/4" x 4" Dexter brake assemblies and the BP01-330 DEXTER fits newer Dexter brake assemblies made after 2017 that are 12-1/4" x 5". We are out of the BP01-301 as well and have…
Hey Ivey, it sounds like you are looking for the Curt part #C35FR. This plugs into a 7-way which you should have at the rear of your 2025 Ram 1500 to give you a 4-way that has the resistors built in to allow the bulb out sensor issue to go away. You…
The spring hanger placement is going to be determined by your axle spacing. For example, if your axles are spaced 33 inches apart, as shown in the attached diagram, a 7K axle slipper spring, like #e74SR, requires a distance of 28-1/2 inches between…
Hi Hank, Having to add on 7" of material to make up the spacing from the frame to the wheel wells isn't really going to be the safest option for your R-Pod. You would need to either increase the height of the frame for the wheels to clear…
Filters
