Dump Trailer Parts

Hey Jerry, thanks for reaching out. The Atlas IV Hydraulic Trailer Jack #ST23FR is a single-acting hydraulic jack, so hydraulic pressure is only used to extend the cylinder. Once the trailer is coupled and the tongue weight is off the jack, the…

The side plates in the Curt Class 5 Universal Weld-on Hitch #C87CR have only been tested by Curt in the vertical position. With that they are not sure how the mounting brackets will hold up if mounted horizontally. I recommend the Buyers Products…

Yes we do; I have added a photo below for you of the dimensions of the Buyers Products Hitch Plate with 2" Receiver Tube - Ford #3371809060A.

Hey James, thanks for the information. For a compatible grease seal you'll need the Grease Seal item #GS-2125DL. This grease seal has a 2.125" I.D. and 3.376" O.D.. It is sold individually. What color are your brake drums? I found the…

The closest size tandem axle fender that we have to yours is a 72" long trailer fender #HP74VR. This fender is designed to work with 16" wheels. It does not have lights but if there is nothing wrong with your lights, you can use them on the…

Hey Wayne, best solution for you would probably be a wireless brake controller like the Curt Echo Mobile part #C51180 which you would need to power from your trailer battery directly on the 1:00 pin of the 7-way. With just this and the stoplight…

Yes, I contacted a Tech at Dexter Axle for verification and the Dexter Axle UFP Idler Hub, #DA54FR is confirmed to be a replacement for the Reliable Brand, Model BT-150A “short” hub on 2,100 lb. axles. The inner & outer races are included but not…

I have a solution for you but you will need to supply your own pipe to get your desired 33-1/4 inch size. The Universal cam-door lock with 1 inch keeper #383200 will allow you to create a bar lock assembly of 33-1/4 inches. With this item you supply…

Hey Garry, thanks for reaching out! The Peterson Clearance or Side Marker Trailer Light w/ Reflector #422800 measure 4-1/16" long x 2-1/16" tall x 1" thick and have 3" mounting hole centers so as long as this matches what you have…

The Dexter 8-283 is an obsolete 2800lb 10 x 1-1/2 inch hub that used a LM67048 inner and a L44649 outer bearing. Unfortunately, we don't have any hubs that would be compatible with the spindles on your axle. Your best bet at this point would be…

Dexter recommends that you check the wires of the brake assemblies of your trailer to determine which magnet would be what you would need. If the wires are white you would need part #BP01-265 and if they are yellow part #BP01-301. However, aside from…

No, they're not the same. The BP01-301 fits 12-1/4" x 4" Dexter brake assemblies and the BP01-330 DEXTER fits newer Dexter brake assemblies made after 2017 that are 12-1/4" x 5". We are out of the BP01-301 as well and have…