2023 Jeep Gladiator Vehicle Cargo Control

Hello Ron. Sadly, the Front Runner Propane Tank Holder #FR47FV will not fit a 20 lb propane tank. According to Front Runner, out of the box it will work with an 11 lb tank. If you need a tank to use with it, take a look at the Ignik Gas Growler X…

Hello Ruthann, thanks for getting in touch. So I have bad new and good news for you. The bad news is that you will need a new 5th wheel hitch base for your new 2024 GMC 2500 with the puck system. The good news is you do not need to buy a whole new…

Hi James; according to Yakima the correct MOD HomeBase for your 2024 GMC Yukon XL is the Medium #Y83DJ. The #Y55DJ is too large to fit. You will have anchor points similar to the picture below in the rear to secure the straps.

Possibly! It depends on the dimensions of the rear cargo area. I don't have a 2018 Toyota 4Runner in front of me, and all I can find online is cubic feet, but I can tell you that the Yakima MOD HomeBase SUV Storage Drawer item #Y55DJ measures…

Hi Kev; the MORryde RV Cargo Sliding Tray with the 80% extension is only available at 72" long x 48 " wide #MR52FR. If you're alright with a 60% extension we have the MORryde RV Cargo Sliding Tray - 60" x 48" #MR85FR.

Hello Nick, The Hitch ball for the Curt #C60642 will sit above or slightly forward of the rear truck axle. I attached 2 pictures of the underbody of the 2022 GMC Sierra, as you can see that the Curt #C60642 sits in the same spot as the B&W…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Jack, If you're talking about a transition plate then you'll want the etrailer Enclosed Trailer Transition Plate #e32JR. This can be installed on either end of the ramp to help make the transition onto easier or at the hinge of the ramp…

Yes, it does Matthew! The Weigh Safe 180 Hitch 2-Ball Mount for 2.5" Hitch item #WS74MR is designed for and will only fit a 2-1/2" receiver.

Tony, it sounds like you're looking for something like the etrailer Soft Tonneau Cover #e52DR for a low profile or #TX279101 for a standard profile. These tonneau covers sit on top of the bed rails, are a soft roll-up style, and sit 1 1/4" (…

Not that one Scott, but I have one that will. The UWS Truck Bed Fender Well Toolbox item #UWS01624 is too tall at 23-1/4". To keep below your bedsides you'll need to use the DeeZee Specialty Series Passenger's-Side Wheel Well Tool Box…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…