2002 Jeep TJ Bug Shield

Hi Hilario, congrats on the new truck! ^___^ If this were my truck and I was installing a retractable cover on it (which I actually did with my Silverado), I would go with the manual RetraxPRO XR Hard Tonneau Cover - Retractable - Aluminum - Matte…

Hi Dan; the WeatherTech Custom Fit Hood Protector #WT94BF only has the small WeatherTech logo in the corner. This does not have "Super Duty" imprinted on the hood protector.

Hey Nate, welcome back! Thanks for getting me the serial number of your RVI3. Seeing that I can confidently say that the Replacement Bullseye Monitor for Curt RVibrake Braking Systems #RVI64FR will work for sure. How long have you had your RVI3?

Hey Rodney! The Replacement Command Center Tablet for Curt RVibrake 3 #C57DQ does not use a USB-C port to charge. It is the older Micro USB port seen in the picture below.

Hey Joel! Yes, the Westin PRO TRAXX Oval Nerf Bars #W79ER will fit your 2026 Ford Explorer ST. These are confirmed to fit all models of the 2026 Explorer. Are you adding these for aesthetics?

When fitting a fifth-wheel hitch like the Curt A20 #C16034 on your 2022 Ford F-350 Super Duty with the BedRug Custom Truck Bed Liner - Full Bed Protection for Trucks with Bare Beds or Spray-In Liners #BRQ17LBK, it is important to the hitch completely…

Hey Matt, welcome back! The Installation Bolt Kit for 5th Wheel Pin Boxes and 5th Wheel to Gooseneck Adapters item #GY86FR uses twelve 5/8" Grade 8 bolts that should be tightened to 160 ft-lbs. This kit is exactly what you need to install the…

It sure is Doug and congrats on your new truck! The TruXedo Pro X15 Soft Tonneau Cover item #TX33TV has been confirmed to fit your new 2026 Ford Maverick. The TS Rails item #TH25FR are going to fit alongside the rails of the Pro X15 item #TX33TV on…

Hey Mike, thanks for reaching out. Yes, it will! The Curt Mounting Bracket for 4-Pole Flat Trailer Connector #C42CR will match right up with the Curt No-Drill Bracket #C57202. You won't have to drill any new holes. The picture I included shows…

Hey Dennis, thanks for reaching out. Yes we do have a braket for attaching the 4-flat plug to the car. For that I recommend the following: - Curt Mounting Bracket for 4-Pole Flat Trailer Connector #C42CR What most people do it use self-tapping screws…

Hey Aaron, great question! The Trailer Mate Trailer Hitch Receiver #TMT67FR is definitely a budget friendly option for a hitch on your 2026 Highlander. This is basically the economy line from Curt. The welds are a little different (but will still do…

We do have a trailer idler hub assembly that uses inner bearing LM67048 (1.25" inner diameter) and outer bearing LM11949 (0.75" inner diameter). The hub is from Dexter, and is the following part number: - Dexter Trailer Idler Hub Assembly…