2015 Chevrolet Express Van BOLT brand vehicle and hitch locks

Hello Tyler, thanks for reaching out. We may have what you need, but I will need more information in order to know what locks will work. Does your ARE cap use the Bolt brand locks that key to your ignition key? If so, the Replacement Lock Cylinder…

Thanks for reaching out, Hal! That's a really good question. Based off what I could find, if the old cylinder worked with your ignition key you would want to get part #BL692918. I included the ignition key compatibility diagram below for you. You…

Hey Jeff, thanks for reaching out. I just went out to our warehouse and measured the P&F Products J-Channel Rail for Enclosed Trailers #PF26FR. The interior dimension of the J-channel I measured at 0.17". What thickness plexiglass were you…

Hey Jonathan, We do have a kit from Infinite Rule for locking pins specifically for that B&W Tow And Stow With Pintle #IR52FR. This comes with the specific locks needed for that pintle hook you have and will have all points lockable. What are you…

Hey there Daniel - it really depends on your trailer height and what you’re loading. The 6' RapidRamps kits (part numbers #e47XV for 5–6-1/2' wide trailers and #e67XV for trailers over 6-1/2' wide) give you a gentler approach angle, which…

Unfortunately The Replacement Lock Cylinder for BOLT Toolbox Latch #BL692917 is not confirmed to fit your 2020 Ford F-350 Super Duty. You will need The Replacement Lock Cylinder for BOLT Toolbox Latch #BL7025636. This lock will work with your side…

Hi Mark; B&W does not have a 3" version of the Tow & Stow Pintle Hook at this time. What you can do is use the #BW77BR for a 2-1/2" hitch along with the BTBRV Magnetic Hitch Receiver Reducer Sleeve #BTBRV74FR. The reducer sleeve…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hi Steve, The Curt Hitch Receiver Reducer Sleeves - 3inch to 2-1/2inch or 2-inch part #C45408 has a pin hole diameter of 3/4". However, since this is adapting all the way down to a 2 inch, you'll need to use a 5/8" pin because the pin…

Hi Steve, I went out to our warehouse for you and measured the shank of the WeightSafe Safe Load Gooseneck Hitch part #WS27MR and the B&W Gooseneck Hitch Ball from the ball and safety chain kit part #BWGNXA2061 confirmed to fit your 2025 Ford…

Hey Ryan! Yes, the Dexter E-Z Flex Suspension Kit #K71-653-00 is what you need for your Grand Design Imagine. The length of this equalizer matches the Dexter 13-122 that came with your trailer, which is the most important factor so you keep the…

Hey Lloyd, thanks for reaching out. We have just the thing. You can replace the main board assembly to make your WF-8955 compatible with Lithium batteries. For that you will need the following: - Replacement Main Board Assembly for WFCO Auto-Detect…