Brake Controller Installation Cold Wire for Brake Control on 2021 Chevrolet Express 3500

Question

Question:

Cold side wire on brake switch on 2021 chevy express 3500

asked by: Chris K

0

Expert Reply:

The 2021 Chevrolet Express is a difficult vehicle as it does not have a cold side on the brake switch for installing the Prodigy P2 Brake Controller # 90885.

Instead you will need a Fuse Circuit Tap # F2526 that will allow you to get power from a fuse(Auxiliary Stop Lamp Fuse) in the engine compartment fuse panel. You can see this process in the video that I linked below.

expert reply by: Bud M

0

Answer 1

The torque specs for 9/16" diameter u-bolts like the U-Bolt Kit for Mounting 5,200-lb to 7,000-lb, Round Trailer Axles part #APUBR-9 will be a range, from 65 ft. lbs. to 95 ft. lbs. If the tie-plates start to bend inside this range that would be…

view full answer...

Answer 2

The Replacement Door for D&W Inc Super Slider Sewer Hose Storage Tubes is included in #A04-0448BK.

view full answer...

Answer 3

The green light on the Progressive Dynamics 4100 Series RV Converter #PD4135K is actually the status indicator light for the interrogated charge wizard. Boost Mode: Indicated by green LED remaining on. Normal Mode: When the battery is between 50% and…

view full answer...

Answer 4

Hey Tyler, thanks for reaching out! The Bauer Products Motorhome Door Lock #BA64FR does seem to have the closest matching cutout requirements at 5-1/4" wide x 4-1/2" tall, so it will work but you might need to modify your cutout a bit in…

view full answer...

Answer 5

Hey Lyn, it's going to come down to the cut out size of the door where the current latch installs. If it's right at 3 inch by 4 inch you'd want the #295-000019 or if it's 5-1/4" wide x 4-1/2" tall you'd want the part…

view full answer...

Answer 6

Based on my research, the CH751 number you mentioned in your question likely refers to the type of key it uses, and not a model number for the latch itself. We do have a large selection of door latches that might work well to replace your existing…

view full answer...

Answer 7

If your 2019 Chevy Express Van 3500 has the tow package there will be a round connector taped behind the rear bumper that a 7-way like the part #A10-7072VP could attach to. Otherwise you'd need to install a 4-way first like the part #118392.

view full answer...

Answer 8

If your 2019 Chevy Express Van does not have any trailer wiring or a hitch there's a strong chance you don't have it but you can verify this by checking the VIN with a Chevy dealer. So for trailer wiring you'd want to start with the 4-way…

view full answer...

Answer 9

Thanks for the picture Don! I do not have anything that connects to that 10-pin so I am hoping you're just at the wrong connector. I have linked a picture below along with an installation video that will show you what the Hopkins item #31345…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

I went out to the warehouse to measure the Firestone Fuse Circuit Tap Kit #F2526 and found it was 11 mm wide.

view full answer...

Answer 12

Use a circuit tester like part #PTW2993 on the wire in the #11 terminal on the black BCM connector, as shown in the diagram I provided. The wire colors can vary during a production run, which is why we typically recommend that folks wire by function,…

view full answer...

Brake Controller Installation Cold Wire for Brake Control on 2021 Chevrolet Express 3500

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching