We think the waterproof seal and potting on this tail light makes it perfect for boat trailers or any light-duty trailer that may be exposed to water - which is all of them. It displays every signal you need: stop, tail, turn, brake, and more.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at this TecNiq 1080 red eight inch long seven function LED trailer tail light for your passenger side and this is a submersible light. Now, this LED tail light is gonna provide seven functions and we're gonna go through those functions just so you can see. And we've got a hooked up system power, so we'll go ahead and turn it on. And there you can see there's your tail light function and then your stop or your brake light function. It's also gonna give you a turn function.
Over this end, you can see it'll have a clearance light. Also, there's a side marker and a side reflector on this side. And then right up here and at the bottom, there is a rear reflector. Now, this light is submersible. It uses a Techsil urethane potting, which will protect the circuit board from vibration and moisture.
And then the case, it's a sonic welded case. Does have a IP68 rating. It has a red impact resistant lens over red LEDs. Makes it more efficient, durable than incandescent bulbs. We are gonna go ahead and turn off the lights again just to show you, there's your tail lights.
And again, we'll do the brake. We'll do the turn signal. And then again, you can see the clearance light there on the side. Turn back on our overhead lights. Now, this is a direct replacement for a standard trailer light.
Now, the mounting hardware to install this is not included. It does have nine inch pigtail wires, which are wired directly into your trailer's wiring. And this light is DOT, Department of Transportation compliant. It does meet the Federal Motor Vehicle Safety Standards 108 Requirements for narrow and wide vehicles. And as we mentioned, the configuration, this is for the passenger side. Now, if you do want the driver's side light, the driver's side light is gonna give you one extra function. It's gonna give you the license plate light. We do so sell that one also separately, it's part number TN32XR. Again, this has a total of seven LEDs. And last thing I'm gonna do is just give you the dimension. Overall length of it, you can see it's right at eight inches long. Height of it, 2-7/8 inches tall. And the total depth of it is also 2-7/8 inches deep. But that's gonna do it for a look at this TecNiq 1080 red eight inch long seven function LED trailer tail light.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.