Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
This compact 1" round light uses a single red LED that lasts up to 100,000 hours. It’s efficient too, drawing just 0.06–0.08 amps at 9V–14V. That means bright, consistent lighting with minimal power draw. The red lens over the red diode gives off a clean, focused glow that stays visible even in low light, making it perfect for marking trailer edges or corners.
If your trailer sees water often, this light is built to handle it. The housing and lens are sealed together into one waterproof unit, rated IP68 for protection against dust and water intrusion. Inside, the circuit board is encapsulated in TecSeal urethane potting for even better defense than typical epoxy potting. Whether it’s rain, spray, or full submersion, the LED and circuitry stay safe and dry.
This PC-rated LED projects a 180-degree arc of red light that can be seen from the front or either side. Mounted properly, it can double as both a clearance and side marker light—simplifying wiring while keeping your trailer visible from multiple angles. You’ll get strong illumination without needing separate lights for each position.
Tight on space? This light tucks neatly into a 3/4" diameter cutout using the included grommet for a clean, recessed finish. At just 7/8" thick, it stays low-profile and out of the way. The 5' pigtail gives you plenty of wiring length for flexible placement, making installation straightforward without extra connectors or adapters.
The lens and body use automotive-grade polycarbonate that resists UV damage and impacts from road debris. Combined with military-grade circuit board construction and vibration-resistant design, this light is made to stay reliable mile after mile—no cracks, leaks, or flickers to worry about.


Ratings & Reviews

Nick S.
12/1/2025
That is great to hear! I am glad the process was easy and I hope the install was as well. It looks great on your vehicle!

Mike L.
2/18/2026
The pigtail wires are 16-gauge which is typical. Hope that helps!!
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.





Mike L.
4/30/2026
We're glad to hear that, good job!