Trailer Light Fuses on 2013 Dodge Ram 3500

Question

Question:

Can they let me know where the fuse located for trailer lites

asked by: John

0

Expert Reply:

F28(Yellow), F29 (Yellow), and F-30 (Pink) are all cartridge style trailer fuses located in the Power Distribution Center near the battery in the engine compartment. Then there is F53 which is a yellow micro fuse also in that same compartment.

expert reply by: Jason S

0

Answer 1

The running light fuse for the trailer lights on a 2013 Dodge Ram Pickup is located in the engine bay fuse box in the F29 cavity. It should be a yellow 20 amp fuse. If the fuse is intact then the easiest way to determine if the problem is on the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

To verify if your 2021 Ford E-450 cutaway chassis for your Class C motorhome is pre-wired for a brake controller you will need to remove the storage slot in the top of your dash. I have included a install video below that shows how to remove the…

view full answer...

Answer 5

The only converter cross-section compatible with a Magnetek 6345 or Parallax 7345RU is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V, which unfortunately is not compatible with lithium batteries. You would need to…

view full answer...

Answer 6

Power centers like the Progressive Dynamics 4100 Series RV Converter w/ Charge Wizard and AC/DC Distribution Panel - 35 Amp #PD4135K are designed to work with the following circuit breaker brands/types, which can all be purchased at your local…

view full answer...

Answer 7

You are correct in that in order to power AC and DC units with shore power, you need a converter. The Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 45 Amp, part #PD4045KA, that you looked at is a good choice for this.…

view full answer...

Answer 8

Since you aren't using a battery for you installation you'll leave the jumper in place that connects the fuse board to the Battery POS terminal and run a ground wire from the Battery GND terminal to the chassis of your trailer. You'll…

view full answer...

Answer 9

Yes the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger part #PD4045KA can absolutely be used with a generator as the power source.

view full answer...

Answer 10

The Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger #PD4045KA actually pulls the heat back in and the quiet fan will only run when the unit gets up to 115 degrees Fahrenheit. My contact at Progressive Dynamics said that you…

view full answer...

Answer 11

In order to run both AC outlets and DC lights off shore power in your ATC Enclosed Trailer you will actually need a AC/DC distribution panel, not a power converter. For this, I recommend using Progressive Dynamics Inteli-Power AC/DC Distribution…

view full answer...

Trailer Light Fuses on 2013 Dodge Ram 3500

Product Page this Question was Asked From

Continue Researching