Videos
for Subaru Crosstrek Owners
Help Articles
for Subaru Crosstrek Owners
Expert Answers
for Subaru Crosstrek Owners
I really like the Saris SuperClamp EX part #SA4025F. This is a lightweight platform rack (which is normally an unheard of combo). That means it'll be easy to install and remove from your vehicle since it's light, but also it'll be very…
view full answer...The Kuat Sherpa 2.0 2-Bike Platform Rack #SH22G (Gray), #SH22B (Black) or #SH22P (Pearl) does not have a way to adjust the position of your bikes, but there will not be an issue with the bikes coming into contact or rubbing against each other. The…
view full answer...The reason why there is a slight slope on the rack is because it helps a bit with ground clearance with the weight of the bikes on the Kuat Sherpa 2.0 2-Bike Platform Rack #SH22G. With the angle, it helps prevent drag in the back. I went ahead and…
view full answer...Yes, there are four options to add a cargo basket directly to a set of raised roof rails. I have listed them below: 84" Long x 50" Wide - Surco Safari Rack 5.0 Rooftop Cargo Basket for Factory Rails item #SPS5084-1101 60" Long x…
view full answer...There are some large rooftop cargo baskets that can mount to your roof side rails without the need for crossbars. Surco offers their 60 x 50 x 5 inch #SPS5060-1101, which weighs 34 lbs, and the 50 x 45 x 5 inch version #SPS4550-1101, which weighs 32…
view full answer...You are correct that there are definite advantages of hitch cargo carriers over roof cargo carriers. You will have less drag improving your gas mileage and you won't have to reach up to the roof of your vehicle each time you load or unload. The…
view full answer...There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…
view full answer...Looking at the slope on the top tube, you will need an adapter bar to allow your beach cruise to sit level across the arms of the #TH45JV Thule Raceway bike rack. The Thule adapter bar would be part #TH982XT. I am including some links to a videos…
view full answer...I measured the distance of the hitch pin hole to the front of the Curt Cargo Carrier for 2" Hitches #C18113 and found it was 29 inches from the center of the hitch pin hole to the furthest part (the front) of the carrier, as you can see in the…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...You're looking for the Replacement Lid Support for Yakima Cargo Boxes #8880683, which will be the direct replacement for your broken Yakima support. You can re-use the hardware from the old hinge.
view full answer...The etrailer Trailer Hitch Receiver #e98912 you were looking at for your 2021 Subaru Crosstrek includes all of the required mounting hardware to get the hitch installed. This hitch has a 525lb tongue weight rating making it perfect for carrying a…
view full answer...