You can easily identify if you have the crew cab or a quad cab by looking at the size of your rear doors. If they are the same size as your front doors, then you have a crew cab, if they are 3/4 the size then you have a quad cab. I have also included…
The most likely scenario that would lead to your right tail light staying on even after it is unplugged is that somewhere along the wires running through your trailer, there is an inadvertent bare connection between your right tail light wire and the…
It sounds like you could have a set of standard fifth wheel rails that most manufacturers use for their fifth wheel hitches to install into. The different manufacturers all make their own brand of rail kit, but they all have basically the same…
The Reese 54917 is a 6" drop shank with a 10 1/4" rise, the Equal-i-zer Weight Distribution Shank #EQ90-02-4400 has a 13" rise and a 9" drop and has an overall length of 12".
I recommend the Equal-i-zer Weight Distribution #EQ37101ET for your 2019 GMC Yukon XL Denali hauling a Forest River Flagstaff weighing 8,300lbs with 830lbs of tongue weight. This hitch is rated for a trailer up to 10,000lbs with a tongue weight of…
I just checked with my contact at Aries and they told me that the only replacement step pad available for the #AA52ZD running boards is the #AA2090133. This pad does not have the chrome plate and it uses only 4 pins but it will fit the AA52ZD running…
Yes, but only the rear set of TorkLift Custom Frame-Mounted Camper Tie-Downs will need to be replaced when upgrading to the TorkLift SuperHitch Magnum Trailer Hitch Receiver part #TLD1102-30 from the factory trailer hitch on your 2011 Ram 3500. The…
I have a solution for you, but the TorkLift #TLD3109 are not compatible with with the SuperHitch #TLD1102 since the new SuperHitch's side plates are going to occupy the same spot where those old tie downs were previously installed. For this…
Each lamp needs to be grounded either through its mounting studs being in direct contact with the trailer frame or by having a jumper wire ran from the lamp to the trailer frame. Ground the trailer connector at the front of the trailer, which will…
That is a tough question to answer as both are excellent manufacturers with their respective pros/cons. In regards to brake actuators, they both make and manufacture them here in the U.S.A. and they both come with a one year warranty. In regards to…
It sounds like you're looking for the Buyers Products Truck Mud Flaps part #337B30LXP which measures 24" wide x 30" tall x 3/8" thick. These are made of durable rubber which is very strong, have pre-drilled holes for an easy…
Hey Rick, yes the 24 shear spring part #MR95UR does fit in place of the 16 you have and it has a stiffer spring characteristic. This would be what you are looking for it sounds like. The higher the number the higher the weight capacity axles it is…
