Custom Fit 2007 Toyota 4Runner Accessories

Because the 2011 Toyota 4Runner comes with either factory side rails that run front to back or crossbars that run side to side, Yakima does not offer a Q-clip option for the vehicle. What I recommend, if the vehicle has a factory 2 inch trailer…

I spoke a representative from Yakima about the Lift Brackets for Yakima ReelDeal or Big PowderHound and PowderHound Carriers - Qty 2, part #Y8860037. They said these brackets will give you almost 4" of additional clearance. The lift brackets do…

Appreciate the photo of your 7-round connector and I have added a diagram showing the pin differences from a 7-way round like yours to a 7-blade, which is what the pins will be for the Hopkins Trailer Connector Adapter - 7-Pole Round Pin to 7-Pole RV…

As you can see in the diagram I provided, the tilt is adjustable up to about 45°. The tilt mechanism has a pin that can be used in two different positions to allow a roughly 15 or 30° degree tilt or the pin can be completely removed for the…

The Rhino Rack Fairing item #RRRF2 is universal and should work well for your Toyota FJ Cruiser. It can fit crossbar dimensions that are 1-1/4" tall x 3-1/2" wide. The best way to pick out a fairing is to go with the length that matches the…

To get the correct measurement of your leg distance, which is the measurement used to fit your fairing, you'll need to measure the distance between your roof rack legs while it is installed. This will let you know what fairings are too big, or…

Sounds like you are looking for a fairing for your roof rack. The Rhino Rack Fairing #RRRF2 is pretty universal and should work well for you. It can fit crossbar dimensions that are 1-1/4" tall x 3-1/2" wide.

The Rhino-Rack's Locking Fishing Rod Carrier #RR574F is great product that will work wonderfully for your application, you can't go wrong purchasing this product. This has universal mounting hardware that fits all popular roof rack bar…

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

For your 2007 Toyota 4Runner, I recommend the Curt Trailer Hitch Receiver #13445. This Class III hitch is confirmed to fit your vehicle, and unlike the Draw-Tite model that you referenced, you will not need to do any trimming or modifications on the…

The widest portion of the #MPG475 that you referenced excluding the crossbar is 53-15/16 inches. Including the bar it's 78 inches.

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…