2005 GMC Sierra Truck Tailgate Lock

Hey Paul! You do not need a wiring extender to use the Pop & Lock Custom Tailgate Lock #PL34FR or #PL54FR. Both have enough wire to work with your 2023 Tacoma Sport long bed.

The correct Pop and Lock tailgate lock for your 2013 Toyota Tacoma with a backup camera is the part #PAL5400 which comes with a lock cylinder that will allow you to key to your truck's key. I attached an install video for this for you to check…

Welcome back Jim. The Pop & Lock Custom Tailgate Lock with Plug & Play T-Harness item #PL34FR is the correct one for your 2016 Toyota Tacoma. It can indeed be installed using the passenger side input wires which are the purple and grey wires…

Yep you have the right harness, just the Pop and Lock harness #PL34FR has been updated allowing it to work with multiple years of the Toyota Tacoma which has added a few more connectors. You'll use the purple and grey wires if installing on the…

Yes, the Pop and Locks tailgate locks we offer for your 2015 Toyota Tacoma will work on the models that have back up cameras including the part #PAL8550. I attached a link to all the locks we offer plus an install video for you to check out as well.

Hello Louis, Congrats on the 1994, that’s a truck you can still work on, and honestly the older trucks are way cooler than the spaceships we drive around today. For your 1994 GMC 1/2 ton Sierra with a stepside bed, the Pace Edwards Full-Metal…

The BAKBox 2 Truck Bed Toolbox part #BAK92601 measures 10" wide so it should not interfere with the trunk lid but you want to measure the clearance between the open trunk lid and the cab to be sure. However, the BAKBox 2 attaches to BAKFlip…

Yes, the Pop and Lock Tailgate Lock part #PAL5411 that you referenced does still allow the backup camera that mounts in the OEM handle to still function as it has a cut out for that to fit into.

Wire colors aren't specified when installing the #PAL8250 because we have found that the wire colors can sometimes change so the only consistent way to install the unit is to test the wires for the correct function. That being said, according to…

The BAKFlip F1 Hard Tonneau Cover #BAK72601, which is a fit for your 2012 Honda Ridgeline, will be installed in the same manner as you see in the attached demonstration video. I also attached a link to the instructions which are somewhat universal…

If the BAKFlip G2 Hard Tonneau Cover #BAK26601 was installed on your 2014 Honda Ridgeline and it was folded back you would have no interference with it and your trunk. If the G2 cover was folded down the door would open basically as tall as the…

Model numbers for tonneau covers can typically be found on the fabric portion of the cover on the bottom side usually towards the tailgate end. If your model number is located there then it would either be on the side rails or on the rail at the…