2005 Dodge Dakota Truck Tailgate Lock

Hey Paul! You do not need a wiring extender to use the Pop & Lock Custom Tailgate Lock #PL34FR or #PL54FR. Both have enough wire to work with your 2023 Tacoma Sport long bed.

The correct Pop and Lock tailgate lock for your 2013 Toyota Tacoma with a backup camera is the part #PAL5400 which comes with a lock cylinder that will allow you to key to your truck's key. I attached an install video for this for you to check…

Hello Louis, Congrats on the 1994, that’s a truck you can still work on, and honestly the older trucks are way cooler than the spaceships we drive around today. For your 1994 GMC 1/2 ton Sierra with a stepside bed, the Pace Edwards Full-Metal…

Yes, the Pop and Locks tailgate locks we offer for your 2015 Toyota Tacoma will work on the models that have back up cameras including the part #PAL8550. I attached a link to all the locks we offer plus an install video for you to check out as well.

The Pop & Lock Custom Locking Tailgate handle #PAL5500 will fit your 2014 Toyota Tacoma but you will need this mounting clip #PL5455CAMB to relocate your backup camera. I've included some videos for you to check out and see how it installs!

The BAKBox 2 Truck Bed Toolbox part #BAK92601 measures 10" wide so it should not interfere with the trunk lid but you want to measure the clearance between the open trunk lid and the cab to be sure. However, the BAKBox 2 attaches to BAKFlip…

I have another option for you, but the Pop & Lock Custom Locking Tailgate Handle #PAL5500 you were looking at is a manual only lock meaning it can only be locked or unlocked via the included key. Instead you will want the #PAL8540 which is…

Yep you have the right harness, just the Pop and Lock harness #PL34FR has been updated allowing it to work with multiple years of the Toyota Tacoma which has added a few more connectors. You'll use the purple and grey wires if installing on the…

Yes, the Pop and Lock Tailgate Lock part #PAL5411 that you referenced does still allow the backup camera that mounts in the OEM handle to still function as it has a cut out for that to fit into.

Hey Gino, you'll want to take a couple measurements to determine what shank you'd need from a Blue Ox Swaypro to allow your trailer to be towed level. You'll want to measure from the top of your hitch opening on your vehicle down to the…

Wire colors aren't specified when installing the #PAL8250 because we have found that the wire colors can sometimes change so the only consistent way to install the unit is to test the wires for the correct function. That being said, according to…

Model numbers for tonneau covers can typically be found on the fabric portion of the cover on the bottom side usually towards the tailgate end. If your model number is located there then it would either be on the side rails or on the rail at the…