2021 Jeep Gladiator Truck Bed Sliding Tray

Hey Lorie, the first thing you need is a BedSlide confirmed to fit your 2021 Chevy Silverado 2500 6-3/4 foot bed like the #BE75ER. Then for everything else you'd want the Complete BedBin kit part #BE94WR. I attached a picture of everything that…

Hey Scott, the correct factory mount install kit for a BedSlide for a 2026 GMC Sierra 3500 would be the part #BE45UV. Do you have a BedSlide already?

Hi Kristian, great question! The etrailer Anti-Rattle Hitch Collar, part #e55YV, works by taking the slack out between your hitch receiver and the shank of your ball mount or hitch-mounted accessory. It clamps around the outside lip of your 2-1/2…

Hey Scott! The etrailer Anti-Rattle Hitch Collar #e55YV is rated for up to 10,000 lbs gross trailer weight and won't reduce the capacity of a properly matched towing setup. As always, your actual towing capacity is determined by the lowest-rated…

Hey Mike, congratulations on the new truck! You can definitely use the two together. The Curt StowPro 2-Ball Mount #C34FR53HY uses a standard 2-1/2" shank, making it a great match for our etrailer Anti-Rattle Hitch Collar #e55YV. It installs…

Hey Greg! The etrailer Anti-Rattle Hitch Collar for 2.5" Hitch Receivers #e55YV is not compatible with a weight distribution hitch. This is really the only restriction for our anti-rattle. If you need an anti-rattle for a weight distribution…

Good question, Aaron. Since your main detail is the GM MultiPro tailgate, I’d be careful here. The B&W Tow & Stow for 2-1/2" receivers #BWTS20066BMP is specifically listed as compatible with the GM MultiPro tailgate, so if tailgate…

Hi Roy, Yes, the 30 Amp Portable Power Watchdog #HU32VR will protect your RV from sustained low voltage as well as power spikes and high voltage. If the incoming voltage drops to 104 volts or below, or climbs to 132 volts or higher, the watchdog face…

Since you have the Thule TracRac SR #TH97RV on your 2021 Toyota Tundra you will need a tonneau cover that installs inside the bed rails. For a folding cover I recommend the BAKFlip MX4 #BAK48409T. If you would prefer a roll up cover then I would…

Hey Raphael, it takes about 15-30 minutes roughly. It's not hard at all and uses basic tools (9/16" socket/wrench and tape measure). A battery-operated drill could definitely speed up the process. It's just a one person install. And yes,…

Truck Trolley test fit the part #TR87VR on the 2023 Ford F-150 and found that it does fit the 5-1/2 foot and 6-1/2 foot beds so it would for sure fit yours. We also had the chance to test fit it on a 2020 model and found that it fit and worked great.…

Hey Jacob, thanks for reaching out. The Westin Custom Fit Truck Bed Mat #50-6405 weighs approximately 45 lbs. It'll fit the 2017-2026 Ford F-250 and F-350 with the 6-3/4' bed. What do you usually haul in your truck bed?