Does Stromberg Carlson Chock Wheel Stabilizers Come with a Wrench

Question

Question:

Does this product come with a wrench ?

asked by: Tim B

0

Expert Reply:

Yes, the Stromberg Carlson Chock Wheel Stabilizers for Tandem-Axle Trailers and RVs # SC47MR comes with a wrench (see attached photo).

expert reply by: Jon G

0

Wrench Included with Stromberg Carlson Chock Wheel Stabilizers
(click to enlarge)

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 9

Thanks for your question, Steve. Installing the Timbren Rear Suspension Enhancement System #T76FR wouldn’t eliminate the need for a weight distribution system if your setup calls for one, they actually serve two different purposes. A weight…

view full answer...

Answer 10

Hey Barry, we have the Curt tow bar lighting kit part #C96JR that is a confirmed fit for your 20221 Jeep Gladiator and is a simple plug in type install like what you are looking for. Then for a charge line to make sure your Gladiator battery is…

view full answer...

Answer 11

Hello Kevin, Thanks for writing in. The main difference between the Power Watchdog Surge Protectors #HU67FR and #HU42VR comes down to the monitoring capability, housing design, and surge protection rating. The #HU67FR is the newer Generation 2 model.…

view full answer...

Answer 12

Hey Mark! The capacity of the TRED GT Camper Leveler with 2 Wheel Chocks and 4 Jack Pads #RR74AP is 5,000 kg so just over 11,000 lbs. That rating is per pair. What will you be using the levelers for?

view full answer...

Does Stromberg Carlson Chock Wheel Stabilizers Come with a Wrench

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching