Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
With this truck bed configuration (6-3/4) on your 2024 Silverado 2500, you'll need a slider hitch so that you can make turns properly without the trailer making contact with your truck. I recommend the B&W Patriot #BWRVK3270…
view full answer...Based on the information you gave, to mount the Ultra-Fab 2" Trailer Hitch Receiver for Trailer Frames #UF35-946403 I recommend boxing the frame at that location. If you don't wish to box the frame, then I instead recommend…
view full answer...If your Husky Brute 4500 isn't extending or retracting properly then I recommend using the manual override to see if it's something internal or if it's an electronic part of the jack. For a replacement electrical…
view full answer...Yes, dielectric grease like the Dielectric Grease for Electrical Connectors #11755 can and should absolutely be used on electrical connectors like your 4-pin trailer connector. Dielectric grease does a great job of protecting your equipment from…
view full answer...The Blue Ox SwayPro Weight Distribution System part #BXW1006 weighs around 95 lbs. It will actually become part of the vehicle's frame once installed therefore does not count towards tongue weight capacity. Please keep in mind that this…
view full answer...A 38 foot travel trailer will without a doubt be susceptible to crosswinds and turbulence from oncoming and passing traffic. A friction sway control like #83660 is what I would refer to as an entry-level solution that works best for trailers 25…
view full answer...We do offer the Blue Ox SwayPro Weight Distribution Systems for underslung trailer couplers; part #BXW0553 for 6K, part #BXW0753 for 8K, part #BXW1003 for 10K, and part #BXW1503 for 15K. Unfortunately, they aren't offered with 2-1/2"…
view full answer...An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. Measuring is not required if you just take a look at your coupler and see where it attaches to…
view full answer...The reason the Blue Ox SwayPro Weight Distribution w/ Sway Control - Clamp On - Underslung - 10K GTW, 1K TW #BXW1003 is only good for minor sway is due to the only sway control being the tension on the chain. If you are expecting to have more…
view full answer...Since you have a recessed bumper on your Keystone Outback, instead of using the 24x60 etrailer Cargo Carrier for RV Bumper #e99049 I recommend going with the: -24x40 etrailer Cargo Carrier for RV Bumper #e99050. This cargo carrier will work better…
view full answer...If you have a 12 volt system on your camper, you will need to wire your 6 volt batteries (in series), like the attached drawing shows. You would need to run a jumper from the positive side of one battery to the negative side of the other battery.…
view full answer...Measuring on the ground to the inside point of contact of each tire is the correct way to determine which chock setup you need. Yours being 16 inches at the closest point would most likely fall within the 16 to 24 inch range of the #FA84-00-4840.
view full answer...Filter Your Search
Contact and Help