Search: trailer lift blocks   >  

Yes the Correct Track Trailer Alignment and Lift Kit part #RR23QX is designed to fit standard axle hangers just like those equipped on your 2018 Forest River Artic wolf Fifth wheel. This kit is designed to add 1-1/4" or 2-1/4" of lift to…

Since your Stevens M416 has an A-frame design the correct coupler setup you'd need for your trailer to use a Lock N Roll Articulating Coupler would be the part #336TS504 which was designed for A-frame trailers for a direct fit that won't…

Yes, there is a 225/75R15 trailer tire that will fit a 15" x 5" trailer wheel, which is from Contender: - Load Range D: Provider ST225/75R15 Radial Trailer Tire #TTWTRTM2257515D - Load Range E: Provider ST225/75R15 Radial Trailer Tire…

A good rule to follow is to allow 6 inches or more of clearance between the sides of the bed and the bottom of the gooseneck trailer to allow for dips and bumps in the road. You will want to check your gooseneck coupler to see if it has an adjustable…

When adjusting the height of a pin box such as #LC1191191 it is important to support the pin box when removing the bolts. I recommend 2 or 3 buddies to give you a hand and make sure no one is beneath the pin box while raising or lowering it. With the…

Fifth Wheel hitches are not universal fits, so you will want to make sure that your hitch is compatible with your 2015 Ram 3500. Part RVK3000. That is an older Companion hitch that is now obsolete. You can use that on your truck if you have a…

The tube spacers that are included with Curt 5th wheel installation kit #C16200 are only used on certain installations. They are not used on your 1998 Chevy pickup truck so you can toss them in a toolbox or workbench. A lot of the Dodge and Toyota…

The square spacers go between the rails and the truck bed where the bolts go through that attach to the nuts on the under side of the bed. They should be placed in the lower corrugation in the bed. Sometimes, a hole for the bolt has to be drilled in…

I can tell you how to easily determine the correct over/under conversion kit for your 2017 K-Z Sportsmen Classic 180THT, though we would not be able to verify a specific fit for any trailer. It's easy to determine the correct over/under lift kit…

I sent your axle info to Dexter and they were able to determine that you have a set of 7k Dexter Torflex axles so the correct lift you need is the part #K71-725-02 which will give you a lift of 3-1/8 inches.

Sounds like you are experiencing a lot of movement in your suspension which is causing the elongation of the back hanger bolt holes. Over time this is going to happen with normal wear, but most likely the wider hangers and narrower springs are…

Normally if the equalizer is tilted like what you have typically it's because the trailer is not sitting level. The side tilted up is typically pointed down towards the ground. It's hard to see in your picuture but it almost could be the case…