Troubleshooting Trailer Equalizer that Tilts to One Side
Published 08/29/2018 >
Question:
center pivot not level/one side high, one side low. tire wearing unevenly on inside. New Genesis Supreme Toy Hauler tandem axle trailer and suspension has come that way. the center pivot shackle never seems to level out but stays with one end high and one end low. Is this a improper installation?
asked by: Ron B
Expert Reply:
Normally if the equalizer is tilted like what you have typically it's because the trailer is not sitting level. The side tilted up is typically pointed down towards the ground. It's hard to see in your picuture but it almost could be the case based on the angle of the frame and the ground in the background.
Otherwise it indicates that either a leaf spring is too long or the center hanger is not properly located. I'd try measuring the distance between all of the hangers on one side of the trailer and compare them to the dimensions of the other side.
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear, 4-1/4" Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- etrailer
more information >
Continue Researching
- Video: All You Need to Know About the Grease Cap, 1.99" OD EZ Lube Drive in with Plug
- Shop: 25 Ft 4-Way Trailer Wiring Harness - Wishbone Style - 25' Ground
- Search Results: trailer leaf springs
- Search Results: trailer leaf springs kit
- Article: Where to Position the Trailer Axle?
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Find if Dexter Heavy-Duty Suspension Kit Will Fit on Trailer
- Q&A: Looking for a 6-1/4" Long U Bolt for a 3,500 lbs Axle
- Q&A: How to Determine Hanger Spacing on a Tandem Axle Trailer
- Q&A: Should I Replace The Brakes On My 4,400 Pound Lippert Axles?
- Q&A: Why is Center Hanger Longer for Tandem Axle Trailer Hanger Kit
- Q&A: Can The etrailer Dual-Pin Two-Speed Jack Be Used For A Landing Gear Set?
- Article: Most Popular Wheel Bearings
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: Trailer Wiring Diagrams
- Article: Trailer Couplers

