Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
There are adapters available which will allow you to use Roadmaster tow bars with Blue Ox towing brackets. The Roadmaster Tow Bar to Blue Ox Brackets Adapter #RM-031 will work with Roadmaster's Blackhawk, Falcon, or Sterling tow bars with serial…
view full answer...The seal we offer part #RG06-050 cross references as the same thing as a Transcom part #171255TB. It would be the exact same as what you have/need.
view full answer...The leaf springs we offer for 3,500 lb axles are 4-leaf setups like the part #e54SR which is 25-1/8 inch long. The next capacity we offer higher than this is 4,500 lb which is also a 6-leaf setup with the part number #e27SR. This one happens to be 26…
view full answer...I attached a wiring diagram for the Solera Power Awning Switch Kit #LC285500 for you to check out.
view full answer...It sounds like you either have a lose connection or a just a bad controller. I would start by ensuring your wires are making full contact in the controller and the motor and that you don't have any cuts or damage in the wires along the way that…
view full answer...To get power to the controller of your Solera Smart Arm 12V Power RV Awning part #LC759404, you need to tap into an existing circuit, or run a power wire from the battery with an inline fuse holder, and a 15 amp fuse, like part #SWC9538, and part…
view full answer...The interior channel width of the Curt adjustable ball mount part #C45900 that you referenced is 3 inches.
view full answer...Since the wiring on your trailer doesn't use the standard colors the best method for determine their function is to simply apply 12V power to each one to see which lights they activate. Once you determine the function for each of the wires you…
view full answer...7-Way connectors like the #A7WCB that you referenced should be wired by function and not color. Since trailer manufacturers can sometimes use non-standard color wires for the taillight functions of their trailer it is best just to determine the…
view full answer...I attached a diagram that shows how most 7-way rounds like the #PK11720 that you referenced will get wired up. As long as you got yours wired up correctly and your trailer taillights and brakes are functioning correctly that's all that should…
view full answer...To replace the ADTH motor on your landing gear the Stromberg Carlson #LC196308 will work perfectly. This motor is rated for 6,500 pounds like your existing unit. For a gear box replacement you'd want the #LG-179015 if this was needed as well.
view full answer...For 3,500 lb axles we have the bearing kit part #BK2-100 which comes with the bearings, seal, races, and a tang washer.
view full answer...Filter Your Search
Contact and Help