Search: double eye spring   >  

Yes, for 5,200 standard trailer axles we have the hub part #8-219-4UC3-EZ which is a fit for 5,200 lb axles and has the bolt pattern of 8 on 6-1/2 inches like you said you need.

All you should need on the fifth circuit of your 5-way is a 12 volt signal to activate the reverse lock out. Have you used a circuit tester like part #PTW2993 to verify you have 12 volts on that pin? Looking at the condition of your 5-way it is…

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

The Replacement Master Cylinder Assembly #T4395100 will not work to replace your Atwood master cylinder model 85841. Since replacement parts for your actuator are obsolete, your only option is to replace the entire actuator assembly. The Demco…

The only tank equipped RV water heat option we currently offer is the Dometic RV Water Heater part #DMC74FR which is a 120 volt unit with 6 gallon tank and gas/electric operation. In regards to installation, this must be performed by a qualified…

MORryde has a version of the X-Factor Crossmember that was designed to work with the CRE3000 you have with the part #MR33WR.

Since you have 7k axles the Roadmaster Comfort Ride kit part #RM-2460 would be what you'd need. There isn't any reason to go with an 8k version since the U-bolt plate it attaches to wouldn't match up to what you have. The flat part that…

Thanks for the picture of your axle label. From that we know you have Dexter 7k axles and that means the Roadmaster Comfort Ride part #RM-2460 that you referenced is the correct shock kit for it.

The MORryde X-Factor Crossmember part #MR33WR is designed for standard suspension so that is the one you will need to use. If your leaf spring hanger brackets are wider than 3" then you will need to drill per the instructions which I have…

The Roadmaster Comfort Ride Shock Absorbers for Tandem Axle Trailers - 5,200-lb to 7,000-lb Axle #RM-2460 is a great option. The leaf spring kit it was paired with is no longer available separately, so if you want both you would need to get the kit…

When installing the Roadmaster Comfort Ride Shock Absorbers #RM-2460 the distance is determined by the first shock you install. According to the instructions, optimum trailer handling is achieved when the shock is at approximately a 30 degree angle.…

You can get the longer U-bolts here; I checked with Roadmaster, and the 2630 are simply 7 inch long U-bolts, so you can use the following: - 3" Round Trailer U-Bolts (Qty 2) #SP01-060 These are 7 inches long so they are the same, and for a…