Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…
view full answer...Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…
view full answer...Hi Alan, welcome back! You can use the Mounting Bolts and Hardware #BRKH12S to mount the Replacement Mounting Bracket for DeeMaxx Disc Brake Caliper #DE55VR to the brake flange.
view full answer...Hey Doug! More than likely the Lippert Center Point #LC1565391 will fit your 2017 Jayco 2035 RKDS. The system is designed for standard center hangers at least 3" wide and measuring at least 2-1/2" from the equalizer hole to the top of the…
view full answer...Good morning Tim! The RV Designer Hitch Pin - 1/2" - Qty 1 #RD83GR measures a little over 3" from the clip hole to the edge of the straight part, just where it starts to bend. So that measurement is the span, and that tells us it'll…
view full answer...I recommend at least 6" of clearance from the top of your bed rails on your 2021 Ram 3500 to the underbelly of your gooseneck or 5th wheel trailer. If using a gooseneck trailer and if you have the factory in bed prep/puck system there are…
view full answer...I understand your worry Tom, and I have a couple recommendations. First is the MORryde ALLTREK 4000 Shock Absorbing Equalizers #MR89DR which has a height of 4-1/2" for the mounting bolts. This is also 6-1/2" in width like the shorter…
view full answer...Hey Mike, since your wheelbase is 33 inches the correct MORryde Alltrek is the part #MR89DR. The distance between the bolt holes left to right is 6-1/2 inches which is close enough to what you have and the vertical dimension is 4-1/2 inches which is…
view full answer...Hello Ric, If there were only a real standard when it came to trailer suspension, things would be a little simpler. I wish you had submitted a picture so I could take a closer look at the shackles. I’ve attached an image of an install we did here at…
view full answer...Hello Jerry, Great question. It all depends on on if it is compatible. If your current set up is not a topwind coupler then it isn't going to work because the #GCSQTW-30008 does not use traditional pin-adjustment holes (please refer to picture I…
view full answer...Hey Alex, welcome back! There's a couple of options for spacers depending on how tall of a lift your 2014 Nissan Xterra has. Timbren recommends leaving a 1/2" gap between the item #TJRC01 and where they contact on your Nissan. How big of a…
view full answer...Hey Dylan - both M-3 plates measure 81-3/4 inches wide, so you'd need to trim off a little bit. The aluminum one #M348FR would be easier to trim, so I'd pick that over the steel one. The hinge runs the full width so you’ll still get solid…
view full answer...