Result: Tester

Hey Jason. The Curt T-Connector Vehicle Wiring Harness for Factory Tow Package item #C55774 is only going to work if your 2015 Ford Transit T250 has the factory tow package. You'll want to look behind your Transit's rear bumper for a group of…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hey Dan. The only DC to DC charger that you might be able to get away with mounting in a battery box is the OptiMate Smart Battery Charger item #MA99JR. It has a weatherproof case but it's still restricted to inside use only. An easier and more…

Hey Steve, The AirLift airbags with internal jounce bumpers are not able to be added to a system without so you would need to get a whole new system. With that said the system with the internal jounce bumpers is going to create a much rougher ride…

Hey Mark, the distance between the mounting holes of the JR Products Magnetic Baggage Door Catch #JR64ZR is 4 inches.

First, use a circuit tester like part #PTW2993 on the black wire exiting the rear of the controller to verify that power is reaching it. If not, there is a 20- or 30-amp fuse in the power distribution box, located under the hood on the driver's…

The most likely cause for the incorrect behavior of your trailer lights, where activating one turn signal causes all trailer lights to blink, is an insufficient ground (or a short to ground) on either the vehicle or the trailer. Since you re-wired…

There's a rocker switch on the side of the 12-Volt Heater and Defroster #PTW5009 that you referenced that allows you to pick heat or fan. If you rock the switch towards the word "heat" it will put out heat and defrost your windshield.

Heater #PTW5009 draws 13 amps at 12 volts which equals out to about 156 watts. I did a little research and from what I could find it is not ceramic.

Hey Huy. I have one locking hitch pin that has a 3/8" usable diameter. It's the Hitch Lock for Kuat Bike Racks item #HL1. This locking pin has a 3/8" pin diameter, an overall length of 5-3/4", and a useable pin span of 3-1/2".…

Hi David; the TowSmart ProClass 7-Blade Trailer Connector w/ Wire Tester #TS86RR uses screw terminals inside the connector to secure the wires. It has a gasket where the wires enter the connector to help keep out water and debris.

For a cover designed to fit over standard 4-way connectors we have the #C58200. Another very helpful idea will be to put dielectic grease on the pins of your 4-way. This will actually be your best way to fight the corrosion. For that you would want…