Hey Adam, yes the B and W hitch part #BW47BR that you referenced is a confirmed fit for your 2025 Toyota RAV4 plug in hybrid. What are you planning on using the hitch for?
The information I have says the #306-X7162 has a ground clearance measurement of 10-1/2". The Curt #C13410 has approximately 12" to 12-1/2" of clearance when measured to the bottom of the receiver. I'm not 100% sure how accurate…
The receiver tube portion of the Curt Trailer Hitch Receiver part #C13002 will extend out past the rear bumper fascia on the 2015 Cadillac SRX so the center knockout panel cannot be reused unless modified. This will be the case for all aftermarket…
Hi Tom! I included a link to the instructions for the B&W Trailer Hitch Receiver - Custom Fit - Class III - 2" #BW47BR that will fit your 2024 Toyota RAV4 Hybrid. We haven't installed one of these in house quite yet, so no install video,…
I have included a picture. In the picture the top drawing is the Draw-Tite hitch #65005. You can see how the receiver sits just below the bumper (and will stick through the optional lower fascia piece, if present). The bottom installed picture is…
We currently have two front mount trailer hitch receivers for your 1996 Chevrolet K1500, the Draw-Tite Front Mount Trailer Hitch Receiver part #65005 and the Curt Front Mount Trailer Hitch Receiver part #31042. They both have a 9,000 lb line pull and…
Hey John, yes we have the Curt hitch part #C15325 which is a heavier duty hitch that fits your 1999 GMC 3500HD crew cab. This is a Class V hitch that has a towing capacity of 16,000 lbs.
Hey Pam, so the highest rated 1-1/4 inch to 2 inch hitch adapters we offer have a 350 lb tongue weight capacity like with the part #e43YR for a straight adapter or the part #e93YR for one with a rise built into the shank. You have to keep in mind…
When we installed the Curt Trailer Hitch Receiver #C94WR on a 2022 Hyundai Tucson we found it to have a hitch height of 17" to the inside top of the receiver. This will put you at 14-1/2" of ground clearance to the bottom of the receiver.…
Installation of the Draw-Tite Trailer Hitch, item #75614, on your 2011 Acura MDX, will not require the purchase of a bumper kit. The hitch will install with the receiver just below the rear fascia of your MDX. We have a Photo of the #75614 hitch…
While there isn't a mosquito net for the Yakima SlimShady part #Y36VR that you referenced the very similar Thule Tepui Tent part #TH8002AW604 does have one available with the part #TH8002X1001. The Tepui is a similar size roof rack mounted tent…
For the Rhino-Rack Sunseeker Awning, #RR32132 that you currently have, there is the Extension Piece for Rhino-Rack Sunseeker Awning, #RR32112. This can be mounted to the side or front to provide either additional roof space or dropped at an angle for…
Filters
